Samsung AC-S38ANBA Series User Manual page 17

Changing the Dust collecting filter section
Dust collecting filter is a high performance filter that removes the fine dust
and cigarette particles in the air. When the Exchange lamp is lit up, follow the
procedure below to change the filter.
1 . Open the filter box door and pull out the Dust collecting filter.
2 . Widen each side of the filter frame with hands and pull out the Dust
collecting filter from the filter frame.
3 . Put the new Dust collecting filter into the filter frame.
4 . After closing the filter box door, plug in the air purifier.
5 . Press the button on the control panel for more than 2 seconds.
The Exchange lamp on the control panel will go off with a 'beep' and it will be
lit up again at next replacing period.
• Pre-filter is a lasting filter, so clean the filter periodically (once a month)
with running water.
NOTE
• Lift up the pre-filter at the groove on the filter section handle(1) and
pull it out in the arrow direction(2).
• Purchase the Dust collecting filter at a service center.
• Depending on the surrounding environment, the Exchange lamp
will not be lit up even though the appliance needs filter replacement.
However, you should press
collecting filter. When pressing
there will be a 'beep' sound.
• When the Exchange lamp is lit up, change Dust collecting filter, Anti-
Allergen filter, and Deodorization filter at the same time.
AC-S38ANBA Series_EN_33956A(4).indd 17
button after replacing the Dust
button for more than 2 seconds,
Dust collecting
filter section
Dust collecting filter
➀
➁
Pre-filter
2013-07-08 오후 6:05:41
17