Troubleshooting; Safety Instruction - NEC MultiSync Soundbar User Manual

MultiSync sound bar Quick Start
1. Turn off the power switch to your monitor.
2. Place the outlet cable and supplied audio cable under the hook which is on the MultiSync
sound bar (Figure 2). Connect the sound bar under the monitor with two screws. If you are
using the 18 inch monitor, you connect the outside two holes (Figure 3). If you are using the
15 inch monitor, you use inside two holes with two brackets (Figure 4).
3. Connect the audio cable to the jack on the back of the sound bar and the other end to the
"Audio out " terminal of the computer.
NOTE: Headphones may be connected to the "Headphones" output on the front of the
MultiSync sound bar. Headphones can be purchased from your local electronics store.
4. Disconnect the power cord from your monitor and connect it to the inlet cable from MultiSync
sound bar (Figure 5-Figure 6).
5. Connect the outlet cable from the MultiSync sound bar to your monitor. Do not connect the
cable to another device.
6. Turn on the monitor and the MultiSync sound bar.

Troubleshooting

LED on "MultiSync sound bar" is not lit
• Power switch should be in the ON position.
• AC Inlet cable and power cord should be connected.
No sound
• Check to see if audio cable is properly connected.
• Check volume setting.
• (No sound on speaker): Check to see if headphone is not connected.
• (No sound on headphone): Check to see if headphone is properly connected.

Safety Instruction

Do not open this unit. There are no user serviceable parts inside and opening or removing covers
may expose you to dangerous shock hazards or other risks. Refer all servicing to qualified service
personnel.
Check the stability of the LCD monitor after installing the MultiSync sound bar. The LCD monitor,
with the MultiSync sound bar installed, should not overbalance when tilted in any direction to an
angle of 10 degrees from its normal upright position.
Follow the other safety instruction and the other notice that the user's manual of the LCD monitor
instructs.
MultiSync sound bar Specifications
Power
Input Impedance
Input Sensitivity
Frequency response
Power Requirements
Current Rating
Headphone/Audio Input Jack Type
Dimensions
Weight
Note: Technical specifications are subject to change without notice.
1 + 1 Watts @ 8 Ohms with 15% THD
> 40k Ohms
500mV input for full output
300Hz - 10kHz
AC 100-240V, 50/60Hz
1.2A (AC OUT 1.05A)
3.5mm Stereo
11.2 in (W) x 1.8 in (H) x 2.9 in (D)
284.9mm (W) x 45mm (H) x 73mm (D)
1.61 lbs / 0.7kg