Mounting A Faceplate Or A Chuck - Nova NEBULA 55600 Operation Manual

2. Double ended 2 Morse Taper method:
a. Lock the Headstock at 0° by using the locking handle on the bed.
b. Firmly install a double ended 2MT alignment tool on headstock.
c. Release the tailstock Alignment Plates by loosening the bolts underneath the tailstock.
d. Slide the tailstock firmly into the other end of the alignment tool as shown in the image below.
e. Tighten tailstock Alignment Plate screws against the tailstock.

4.7 Mounting a Faceplate or a Chuck

The thread size of headstock Spindle is 1.25" RH (Standard version), or M33 ASR RH (Euro ASR version), depending on
your model.
Standard version spindle
1 ¼"
17
128-0521-002
2MTNA Tool
Euro ASR version spindle (with locking ring flange)
M33