Coleman Kraz X1 Installation Manual

POLE ASSEMBLY PART
Main Tent Pole
Part No. 9830-1191
Foot Pole
Part No. 9830-1291
Rainfly
Part No. 9830-1391
1
Layout & Positioning
of Tent, Pole Assembly
– Layout and position tent with doors facing
desired direction. (illus. 1)
– For best results in windy conditions position
end of tent into the wind.
– Stake down tent corners using the stake loops.
Keep the floor taut. Unzip doors. (illus. 2)
– Assemble Frame Poles by interlocking
shock-corded sections. This will make one long
and one short "U" shaped pole.
– Insert the longer pole through the pole sleeve
located in the middle of the tent and the shorter
pole into the sleeve at the foot of the tent. (illus. 1)
2
Connect Frame to Tent
– Insert one Pole Talon™ into pole on stake loop
located at middle edges of the tent.(illus. 3)
– Go to opposite end of pole and
gradually apply pressure to the
pole forming an arch until you
are able to insert the pole talon
into the pole.(illus. 3 & 4)
– Attach Frame Clip on each
side of tent. (illus. 5)
– Tie frame ties
around the tent pole.
Kraz
™
part number 2000000451
Two side doors
Pole Sleeve
illus. 1
illus. 2
Tent stake
through Loop
illus. 5
Frame Clips
illus.4
Tent completely set up and
staked out.
X 1
illus.3
Insert Pole Tip
into grommet