Cable Management; Using The Remote Control; Battery Installation And Replacement; Operating Range - NEC PlasmaSync 42XR4 Operation Manual

Cable Management

Using the cable clamps provided with the plasma display;
Bundle the signal and audio cables at the back of the unit
to connect to the display.
42 inch
Back of the unit
mounting holes
50-61 inch
Back of the unit
mounting holes
To attach
1.
clamp
mounting hole
To detach

Using the remote control

Battery Installation and Replacement

Insert the 2 "AAA" batteries, making sure to set them in
with the proper polarity.
1.Press and open the cover.
2.Align the batteries according to the (+) and (–) indication
inside the case.
2.
cables
3.Replace the cover.

Operating Range

* Use the remote control within a distance of about 7 m/
23ft. from the front of the monitor's remote control sensor
and at horizontal and vertical angles of up to approximately
30°.
* The remote control operation may not function if the
monitor's remote control sensor is exposed to direct
sunlight or strong artificial light, or if there is an obstacle
between the sensor and the remote control.

Handling the remote control

• Do not drop or mishandle the remote control.
• Do not get the remote control wet. If the remote control
gets wet, wipe it dry immediately.
• Avoid heat and humidity.
• When not using the remote control for a long period,
remove the batteries.
• Do not use new and old batteries together, or use different
types together.
• Do not take apart the batteries, heat them, or throw them
into a fire.
En-6
ON/STANDBY
Approx.
7m/23ft