Nesting Screen - Swift-Cut Swifty 1250 Installation And Operation Manual

To adjust the parameters (if required), use the -/+ buttons to change values. This will adjust
the shape.
4.1 Press the 'OK' button.
The Working Type screen will open, where any adjustments can be made (refer to Paragraphs
5 to 10 of this sub-section).
When all of the required parts are in the job library, press the 'Next' button to proceed onto
the Nesting screen.

Nesting Screen

The Nesting screen (Fig 55) displays the cutting table outline (yellow), the size of the material
set in the Job settings (green), and the trim value (purple).
The part thumbnail (in the 'Job Library' column) contains two numbers:
2.1 The quantity to be cut (in Fig 55 this is shown as 3).
2.2 The quantity currently nested (in Fig 55 this is shown as 0).
3
The Advanced version of SwiftCAM will automatically nest parts from the Job Library onto
the sheet. If the parts do not fit on one sheet, a second sheet will automatically be created. The
numbers in the bottom right hand corner shows sheet information (Fig 55 (2)). The arrows can be
used to switch between sheets if multiple sheets have been created.
For the Standard version of the software, to add the part to the nest preview proceed as
follows:
4.1 Select the part in the Job Library column.
Version 1.1
May 2019
4 5
Fig 55 Nesting screen (Standard version)
Section 3 – Operation
2
1
Page 63