Remove Monitor Stand For Mounting - NEC MultiSync LCD1530V User Manual

Quick Start
Tilt
Grasp both sides of the monitor screen with your hands
and adjust the tilt as desired (Figure TS.1).

Remove Monitor Stand for Mounting

To prepare the monitor for alternate mounting purposes:
1. Remove the connector cover, hinge cover
and cable cover (Figure R.1).
2. Disconnect all cables.
3. Place monitor face
down on a non-
abrasive surface ( place
the screen on a 32 mm
platform so that hole of
stand match to screw
location).
(Figure R.2).
4. Remove the 4 screws
connecting the
monitor to the stand
and lift off the stand assembly
(Figure R.2) the monitor is now ready
for mounting in an alternate manner.
5. Connect the AC cord and signal
cable to the back of the monitor.
6. Reverse this process to
reattach stand.
1530v
ブラック
–continued
Figure R.1
32mm
Screws
6
8
Figure TS.1
Push Push
Figure R.2
0.9.25, 5:13 PM