Installation, Cont'd: Glass Shelving / Electrical Connections - Structural Concepts Harmony HMG2642R.4439 User Manual

INSTALLATION, CONT'D: GLASS SHELVING / ELECTRICAL CONNECTIONS

4. Glass Shelving
Glass shelving will be packed separately.
• Caution! Carefully remove from packaging.
• Grasp firmly and carefully install.
• Caution! Check that plastic edging is intact
before placing glass shelving onto brackets!
• Plastic edging must NOT be removed from
glass shelves. Contact Structural Concepts for
replacement edging (see TECHNICAL
SERVICE CONTACT INFORMATION section).
• Check that glass shelving is in proper position
before placing product in case.
• See illustration at mid-right.
5. Electrical Connections
Remote Units
• Remove front or rear panel (by removing
screws and lifting off case)
-------- Self-Contained Unit --------
• Knockouts are located on side and rear of
electrical box.
•
Single phase leads are provided.
• See serial label (at case rear) for voltage rating.
• See illustration at lower-right.
Self-Contained Units
Field wiring connection / junction box location is at
rear-right of case.
• See illustration at below-left.
• Single phase leads are provided.
• Plug unit into wall outlet.
• See serial label (at case rear) for voltage rating.
Note: Wiring process must be performed by
certified electricians only.
Glass
Shelves
Knockouts
6
-------- Remote Unit --------