Advertisement
Before replacing the lamp
unit and air filter
■ Checking the lamp unit to be
replaced
Check the status of the lamp
indicators <LAMP1>/<LAMP2>.
z The lamp unit corresponding to the lamp indicator
that is lit in red is required to be replaced.
Main unit operating part
<Power indicator>
(ON (G) / STANDBY (R) )
Power ON〈 〉button
<MAIN POWER> switch
Attention
z Panasonic Connect Co., Ltd. shall not be
responsible for damages or malfunctioning of the
product due to the use of other than a Panasonic
Connect Co., Ltd. lamp unit. Use only specified
lamp units.
z Do not use replacement lamp units (for portrait
mode) and normal lamp units together. Check
the product number on the label attached to the
replacement lamp unit.
z A replacement lamp unit (for portrait mode) must
be used when installing in a portrait orientation.
z Do not install the projector in any orientation other
than portrait when using a replacement lamp unit
(for portrait mode).
z When replacing the lamp unit, please also replace
the air filter on the relevant side.
z Since the luminous lamp is made of glass, it may
burst if dropped or hit with a hard object. Please
handle with care.
z Do not disassemble or modify the lamp unit.
z When replacing the lamp unit, be sure to hold it
by the handle because its surface is pointed and
its shape is protruded.
z The lamp may burst. Replace the lamp unit
carefully so that the broken pieces of the lamp
glass will not scatter.If the projector is to be
attached to the ceiling, do not perform the work
while directly beneath the lamp unit or put your
face close to it.
<Lamp indicator>
（LAMP1, LAMP2）
z The lamp contains mercury. When disposing of
used lamp units, contact your local authorities or
dealer for correct methods of disposal.
z Panasonic Connect Co., Ltd. recommends
that the lamp unit be replaced by a specialized
engineer. Contact your dealer.
Note
z A Phillips screwdriver is necessary when
replacing the lamp unit and air filter.
Switching off the projector
When the projector is operating, perform the follow-
ing steps to turn off the projector, and wait until the
lamp unit cools off then make the replacement.
1) Press the power standby <
button.
2) Press ◀▶ to select [OK], and
press the <ENTER> button.
(Or press the power standby <
button again.)
z Projection of the image will stop, and the
power indicator <ON (G)/STANDBY (R)> on
the projector lights in orange.
(The fan keeps running.)
3) Wait until the power indicator
<ON (G)/STANDBY (R)> of the
projector lights in red (and the
fan stops) for approximately 170
seconds.
4) Press the <OFF> side of the <MAIN
POWER> switch to turn off the
power.
>
>
ENGLISH-3
Advertisement
