Table of Contents
Advertisement
®
R&S
RTP-K28
To start the R&S ScopeSuite on the instrument, in the R&S RTP firmware:
► In the "Apps" dialog, open the "Compliance" tab.
2.5 Connecting the R&S RTP
If the R&S ScopeSuite is installed directly on the instrument, the software detects the
R&S RTP firmware automatically, and the "Oscilloscope" button is not available in the
R&S ScopeSuite.
If the R&S ScopeSuite software runs on a test computer, the computer and the testing
oscilloscope require a LAN connection, see
on page 8. The R&S ScopeSuite software needs the IP address of the oscilloscope to
establish connection.
1. Start the R&S RTP.
2. Start the R&S ScopeSuite software.
3. Click "Settings" > "Oscilloscope".
4. Enter the IP address of the oscilloscope.
To obtain the IP address: press the Rohde & Schwarz logo at the top-right corner
of the oscilloscope's display.
5. Click "Get Instrument Information".
The computer connects with the instrument and gets the instrument data.
User Manual 1179.6472.02 ─ 01
Preparing the measurements
Connecting the R&S RTP
Chapter 2.3, "Setting up the
network",
9
Advertisement
Table of Contents
Need help?
Do you have a question about the R&S RTP-K28 and is the answer not in the manual?
Questions and answers