Johnson Controls tyco iSTAR Edge G2 Installation And Configuration Manual page 14

Chapter 1 - Overview
I/Os
Power limit of the port cannot be exceeded when configuring the ports.
NOTE
• x8 general purpose inputs.
• x4 general purpose relays.
— Dry or wet contact settable per relay by jumpers.
• x8 I8s and x8 R8s can be configured on any of the 4 RM ports.
• Special purpose inputs:
— Tamper (from enclosure door).
— Main AC fail (from aPS).
— Low external battery (from aPS).
• Large standard two-piece terminal blocks.
• x4 RM serial ports.
• x2 USB (Type A) host ports.
Communications
• x2 Ethernet ports (10/100/1000) - x1 port with PoE.
• Full 256-bit AES (FIPS 197 encryption).
• iSTAR Edge G2 can only cluster with other iSTAR units supporting TLS v1.3.
Onboard Controls
• LCD with backlight for diagnostics.
• Rotary switch for diagnostics.
• LEDs for serial, Ethernet, power, and relay state.
— x2 power LEDs - 1 is on when the enclosure door is closed and 1 indicates the controller is powered.
Relay activation LEDs state is not affected by enclosure door position. All other LEDs light up when the enclosure door is open.
NOTE
• Reset button.
• Switches for serial termination of RM ports.
• Jumpers for relay wet/dry control.
Housing
The iSTAR Edge G2 can be mounted in:
• apC/L enclosures.
• GSTAR-CAN enclosures to maintain UL-listing.
iSTAR Edge G2 Controller Installation and Configuration Guide 14