Assembly And Setup; Wall-Mounting Setup Method - Hitachi HTCB-77G User Manual

Cambridge Board

1.3 Assembly and Setup

1.3.1 Wall-Mounting Setup Method

(1) Attach the Wall-Mount Bracket to a wall using the appropriate hardware for the type of
wall (hardware not included). The wall bracket should be level and positioned at a
height that results in the final position of the Cambridge Board being such that users
can comfortably reach the top corners of the active surface.
(2) Hang the Cambridge Board on the wall bracket as shown below.
(3) Stabilise the Cambridge Board using the Whiteboard stabiliser. Refer to the instructions
of the Whiteboard stabilisers for details.
You can also use the floor stand. Please refer to the instructions of the floor stand for details.
Before installation, take the wall material into consideration.
If it is installed using a method inappropriate for the type of wall, the board might fall
and cause serious injuries. Also, installation might be impossible, depending on the type
of wall. For details, consult your dealer.
Before installation, take the wall strength into consideration.
Before using the Cambridge Board, make sure that it has been fastened securely so that
it will not fall. Also verify that the wall mounting bracket is strong enough to support a
weight of approximately 40 kg/screw.
This work should be performed by at least two people.
Otherwise, the board might fall and cause injury or its impact might cause damage.
Whiteboard Frame
CAUTION
1-6
Wall
Wall-Mounting
Bracket
Introduction
English