Replacing The Canister; Rinsing Agent - Miele PFD 402 Operating Instructions Manual

en - Cleaning agent and rinsing agent
Liquid cleaning agent is dispensed from an
external canister via a suction lance.
Depending on the model, liquid cleaning
agent is dispensed either via an internal dis-
pensing pump or via an external dispensing
module. Dispensing modules are connected
by the Miele Customer Service Department
and can be retrofitted at any time.

Replacing the canister

Place the liquid cleaning agent container

(note the colour marking) on the open
wash cabinet door or on a surface which
is robust and easy to clean.
Take the lid off the canister and remove

the suction lance. Place the suction lance
on the open wash cabinet door.
Replace the empty container with a full

one.
Push the suction lance into the opening of

the container and secure the lid. Observe
the colour coding.
Feed the suction lance into the container

until it reaches the bottom.
Wipe up any spilled process chemical

thoroughly.
62

Rinsing agent

Rinsing agent is necessary to ensure water
does not cling and leave marks on load
items, and to help load items dry faster after
the final rinse.
The rinsing agent concentration must be ad-
justed in the following circumstances:
- If there are spots of water left on load
items after reprocessing, then the dis-
pensing concentration is set too low.
- If clouding or smearing appears on load
items, the dispensing concentration is set
too high.
The rinsing agent is dispensed in the
rinse
programme stage. The container
needs to be filled for this purpose.
Final