Installation Of The Hp Lights-Out 100C Remote Management Card; Remote Management Card Kit Contents; Preinstallation Procedures - HP ProLiant ML110 G4 User Manual

Installation of the HP Lights-Out 100c Remote
Management Card

Remote management card kit contents

Installation of the HP Lights-Out 100c Remote Management Card is required to activate the optional
features of the HP ProLiant ML115 G1, ProLiant ML110 G4, and ProLiant ML150 G3 servers. See
"LO100 optional features (on page 6)" for more information.
The HP ProLiant Lights-Out 100c Remote Management Card Kit includes the following components:
•
HP Lights-Out 100c Remote Management Card
•
Spacer support
•
Remote management card installation instructions

Preinstallation procedures

The installation procedures in this document are intended for individuals who are qualified in the servicing
of computer equipment and trained in recognizing hazards in products with hazardous energy levels.
WARNING:
serious damage to the equipment as well as bodily harm.
CAUTION:
management card.
IMPORTANT:
when installing the remote management card.
NOTE:
stable surface.
Back up the server data.
1.
Shut down the operating system as outlined in the operation system instructions.
2.
Power off the server and all the peripherals connected to it.
3.
Unplug all cables from the power outlets.
4.
Label each cable, if not already labeled, to expedite reassembly.
5.
Disconnect telecommunication cables to avoid exposure to shock hazard from ringing voltages.
6.
Open the server according to the instructions described in your server manual.
7.
Failure to properly turn off the server before you open the server may cause
Follow the ESD precautions listed in your server guide when handling the remote
Observe the pre- and post-configuration procedures described in later sections
The procedures described in this section assume that the server is positioned on a flat,

Installation of the HP Lights-Out 100c Remote Management Card 8