STREAMLIGHT PORTABLE SCENE LIGHT II - Portable Scene Light Manual

SAFETY

1. BEFORE USING YOUR PORTABLE SCENE LIGHT II AND CHARGER, READ ALL INSTRUCTIONS IN THIS MANUAL AND ALL CAUTIONARY MARKINGS ON THE CHARGER.
2. While eye damage from the PORTABLE SCENE LIGHT SCENE LIGHT II is unlikely, you should NOT STARE INTO THE BEAM.
3. 
   Never leave your PORTABLE SCENE LIGHT II with its lamp face against any surface including skin while in operation. The resultant heat build-up can cause a fire or burns.
4. The PORTABLE SCENE LIGHT II is not approved for use in hazardous atmospheres.
5. Do not subject the AC charger to water or rain.

Use ONLY a 12VDC vehicle power source OR approved Streamlight AC chargers.

6. PORTABLE SCENE LIGHT II contains hi-capacity Lithium Ion battery packs. Replacement batteries should be installed by Streamlight's service department or an authorized Streamlight service center.

BATTERY CAPACITIES & TRANSPORTATION

The Streamlight PORTABLE SCENE LIGHT II contains two of our highest capacity Lithium Ion (Li-Ion) battery systems to date. Streamlight has developed the main battery disconnect to allow the PORTABLE SCENE LIGHT II to be safely transported according to the United States Department of Transportation regulations.

The total amount of energy in a battery is measured in Watt Hours, which are calculated by multiplying voltage (V) by amp hours (Ah). Batteries over 100Wh are categorized as Class 9 Hazardous Goods.

Streamlight's PORTABLE SCENE LIGHT II contains two 56Wh batteries for a total of 106 Wh. THE PORTABLE SCENE LIGHT II main power disconnect effectively shuts off the power to the unit and separates the two battery packs for safe normal shipment.

The PORTABLE SCENE LIGHT II will ship from Streamlight with the main battery disconnect switch in the Ship (OFF) position. We strongly recommend that you use this safety feature when shipping.

It is ultimately the sender's responsibility to correctly ship units containing Li-Ion batteries according to dangerous goods transportation regulations and freight rules. Failure to do so may result in prosecution by Dangerous Goods transportation authorities.

NOTE: MAIN BATTERY DISCONNECT SWITCH MUST BE PLACED IN THE ON POSITION AND THE UNIT MUST BE FULLY CHARGED BEFORE OPERATION.

• Remove the waterproof cover located under the charge port cover. DO NOT DISCARD.
  
  
• Insert a pen into the switch hole in the back cover and slide the switch towards the left to turn unit on.
  
  
• Install the cover in the back panel. FAILURE TO INSTALL THE ROUND COVER ONTO THE REAR PANEL WILL RESULT IN A COMPROMISE OF THE WATER INGRESS RATING AND MAY DAMAGE THE UNIT.
• Remove tape and foam switch shipping protector.
  

OPERATION

• The PORTABLE SCENE LIGHT II features five intensity settings. A momentary two position toggle switch controls the On/Off and operation of the high-intensity LED light source settings. Push the switch briefly up or down to turn on unit. Toggling the switch upwards will increase the intensity setting. Toggling the switch downward will decrease the intensity setting.
  
  
• To turn off the unit, hold the switch up or down for 1 second. The unit will remember the last intensity setting.
  
  
• The PORTABLE SCENE LIGHT II LED head can be rotated to various positions as required.
  
  
• The PORTABLE SCENE LIGHT II can be stacked up to three units for increased intensity.
  
  
• The PORTABLE SCENE LIGHT II can hang from doors, guard rails, etc.

AC CHARGING

To charge the PORTABLE SCENE LIGHT II, remove the charge port cover and insert the charge cord connector into the charge port adjacent to the display. The charge cord connector is keyed and will only fit one way onto the charge port connector. The display will read out the percentage of charge. The PORTABLE SCENE LIGHT II may need as little as a few minutes or up to 6 hours to fully charge depending on the battery's state of charge. Upon charge completion, replace the charge port cover.

Note: The PORTABLE SCENE LIGHT II battery will continue to charge while the light is being operated.

DC VEHICULAR CHARGING

The PORTABLE SCENE LIGHT II will charge from a 12V DC source using a Streamlight (P/N 22050) DC direct wire cord.

Before making electrical connections in a vehicle, keep in mind that a shorted vehicle battery can easily start a fire. Make all connections with insulated lugs or other connectors intended for such use. Be sure that your installation is fused (A ten-amp fuse must be used on the positive lead). The red or red striped lead is positive and the unmarked lead is negative. When connecting the charger to a fuse block, the red positive power lead goes to the connector that is dead when the vehicle's safety fuse is removed.

Streamlight recommends connecting the PORTABLE SCENE LIGHT II to an unswitched source of power to ensure is always fully charged. If connected to a battery in a vehicle that will not be driven for several days the PORTABLE SCENE LIGHT II will draw 100mA per hour and may need to be monitored to avoid excessive vehicle battery drain. Charging a PORTABLE SCENE LIGHT II with its battery fully discharged draws as much as 5 amps until the battery is fully charged and up to 100mA continuously in the maintenance. The PORTABLE SCENE LIGHT II also draws approximately 6.5 ampere hours while charging and operating in the mode.

Streamlight's Limited Lifetime Warranty
Streamlight warrants this product to be free of defects for a lifetime of use except for batteries and bulbs, abuse and normal wear. We will repair, replace or refund the purchase price of this product should we determine it to be defective. This limited lifetime warranty also excludes rechargeable batteries, chargers, switches and electronics which have a 2 year warranty with proof of purchase. THIS IS THE ONLY WARRANTY, EXPRESSED OR IMPLIED, INCLUDING ANY WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. INCIDENTAL, CONSEQUENTIAL OR SPECIAL DAMAGES ARE EXPRESSLY DISCLAIMED EXCEPT WHERE SUCH LIMITATION IS PROHIBITED BY LAW. You may have other specific legal rights which vary by jurisdiction.

Go to www.streamlight.com/support for a complete copy of the warranty.
Retain your receipt for proof of purchase.

MAINTENANCE

Should your PORTABLE SCENE LIGHT II need service we recommend returning it to the Streamlight Repair Department or a Streamlight Authorized Service Center. If you decide to repair the PORTABLE SCENE LIGHT II yourself use ONLY official Streamlight replacement parts and carefully follow the specific instructions packaged with the parts.

For Factory Service Please Contact Us:
Customer Service
STREAMLIGHT, INC.
30 Eagleville Road
Suite 100
Eagleville, PA U.S.A. 19403-3996
Phone: (800) 523-7488 Toll-Free
Fax: (800) 220-7007