Everbilt 7252-25-14-KIT-EB Installation Manual

TOOLS REQUIRED
Safety goggles Phillips screwdriver
Installation
1
PREPARING FOR INSTALLATION
Pick a cold water supply pipe located as close as possible to the appliance.
Close the main water shutoff valve. Open a faucet located near the
installation to relieve pressure in the line.
3A
POLYETHYLENE TUBE CONNECTION
Use 1/4 in. coupling union (F) (provided) to connect the water inlet to the
Polyethylene tubing (A). First slide the compression fitting (C) (provided)
into Polyethylene tubing. Insert one of the small brass tube stiffeners
(D) (provided) into the end of the line pressing it until the flare on the
stiffener touches the end of the plastic tubing. NOTE: A brass stiffener
(D) must be placed inside the end of the tube so it can be attached
via compression fitting (C) without being crushed and creating a leak.
Check to ensure that the tube is completely inserted into the union (F).
Tighten the fitting on the union (F) until Polyethylene tubing is secured in
place using adjustable wrench. DO NOT OVERTIGHTEN.
Coil at least 8 ft. of tubing behind the refrigerator to allow the
refrigerator to be moved away from the wall for cleaning and servicing.
Run tubing to the cold water supply pipe.
Installation Guide
Polyethylene Ice Maker
Supply Line Kit
Adjustable wrench
C
A
PACKAGE CONTENTS:
A - 1/4 in. OD x 25 ft. B - Saddle
Polyethylene tube valve (1)
E - Adapter (1) F - Union (1)
2
CONNECTING TO A WATER INLET
Connect one end of the Polyethylene tube (A) to water inlet located
on the back of the refrigerator. First slide the compression fitting (C)
(provided) into Polyethylene tubing. Insert one of the small brass tube
stiffeners (D) (provided) into the end of the line pressing it until the flare
on the stiffener touches the end of the plastic tubing. NOTE: A brass
stiffener (D) must be placed inside the end of the tube so it can be
attached via compression fitting (C) without being crushed and creating
a leak. See 3A or 3B to attach depending on your application.
A
NOTE: The water valve connection will differ by type of refrigerator. Adapter (E)
may need to be used.
3B
THREADED CONNECTION
Slide a compression fitting (C) (provided) onto Polyethylene tubing (A). First
slide the compression fitting (C) (provided) into Polyethylene tubing.
Insert one of the small brass tube stiffeners (D) (provided) into the end
of the line pressing it until the flare on the stiffener touches the end of
the plastic tubing. NOTE: A brass stiffener (D) must be placed inside the
end of the tube so it can be attached via compression fitting (C) without
being crushed and creating a leak. Check to ensure that the tube is
completely inserted into the union. Tighten the fitting on the threaded
connection (E) until Polyethylene tubing is secured in place using
adjustable wrench. DO NOT OVERTIGHTEN.
Coil at least 8 ft. of tubing behind the refrigerator to allow the
refrigerator to be moved away from the wall for cleaning and servicing.
Run tubing to the cold water supply pipe.
Item #1001 274 435
Model #7252-25-14-KIT-EB
C - Compression
fittings (2)
C
Please contact 1-800-305-1726 for further assistance.
D - Brass
stiffener (3)
D
HOMEDEPOT.com
11-18-16