Table of Contents
Advertisement
Installing the Software and
Wireless System Controller
IMPORTANT: Do not connect your Wireless System Controller to your
computer until the Installation Wizard instructs you to do so.
1
Insert the enclosed Motorola homesight CD in the CD-ROM drive. The
Motorola homesight Installation Wizard is displayed.
a.
If the application or autorun does not appear, right-click the Start
button and select Explore.
b.
Select your CD-ROM and double-click to open.
c.
Double-click Launch.exe to start the application.
2
Click Next. The Choose Destination Location window is displayed.
3
Click Next to accept the default destination folder, or click Browse to
select a new one. After you click Next, the Select Program Folder window
is displayed.
4
Accept the default folder or choose a new one. Click Next. The file installation begins. After a few
moments, the Install Motorola homesight Hardware and Driver window is displayed.
5
Plug the AC adapter (red plug) into the Power port on the Wireless System Controller and into an AC
wall outlet. This powers on your Wireless System Controller.
6
Connect the USB cable on the Wireless System Controller to the USB port on your computer. Windows
automatically installs the required drivers.
7
Once the driver installation is complete, click Next. "The Software installation was successful" window
is displayed. Be sure the checkbox "Launch Motorola homesight" is selected.
8
Click Finish. The Motorola Setup Wizard is displayed. Follow the on-screen steps for installing the
Motorola homesight software.
Installing Your Camera
Your camera can either be mounted on a wall or just sit on a level surface.
Wall Mount Your Wireless Motion Sensor Camera
Discover your sensor before mounting it.
Make sure the power adapter cord is long enough to reach your mounting location. Also, be sure
the AC outlet cannot be switched on and off with a wall switch.
1
Using the holes on the drilling template found later in this guide, mark the position of the
holes to be drilled.
For drywall or other composite surfaces, use a 7/32" drill bit. Drill
screws and insert a plastic wall anchor into each hole.
For other solid surfaces, use a 1/16" drill bit. Drill a pilot hole for each of the mounting screws.
2
Using the screws provided, secure the camera mounting bracket to the wall. Pull off the camera base b
pulling straight down. The base detaches from the upper back side. Slide th
bracket until it is firmly seated and you feel it click as the contacts engage.
a hole for each of the mounti
4
Wireless
System
Controller
PC
ng
e camera down on to the
y
Advertisement
Table of Contents
