Muse M-1932 DJ - Party Box Bluetooth Speaker Manual

Please read the instruction carefully before operating the unit.

LOCATION OF CONTROLS

MAIN UNIT

1. MIC. 1 Jack
2. MIC. 2 Jack
3. AUX IN jack (3.5MM)
4. USB port for charging (5V 1A)
5. USB port for MP3 playback
6. REPEAT button
7. / PREV (previous) button
8. : PLAY/ PAUSE/ Disconnect Bluetooth connection
9. / NEXT button
10. MUTE button: To mute or restore sound
11. MIC. FIRST button
12. Front light mode button
13. Speaker light mode button
14. MIC. ECHO knob
15. MIC. VOL knob
16. MEGA BASS button: To enhance the bass power
17. / M (Standby ON/ OFF/ Mode) button
18. TONE button: To adjust bass/ treble
19. EQ button: To select desired sound effects
20. VOL knob
21. Display
22. Front color light
23. Tweeter
24. Loud speaker
25. Back handle
26. AC input socket
27. Power ON/OFF Switch
28. Wheels
29. FM antenna

POWER SUPPLY

1. Connect the detachable AC cord (included) to the AC socket on the rear of the unit.
2. Plug the power cord into 100-240V ~ 50/60Hz AC outlet.

TURNING UNIT ON/OFF

1. Slide the POWER ON/OFF button to ON position, the unit will power on automatically and the display will light up.
2. Press and hold button to enter standby mode.
3. Press to power it on again.
4. Slide the POWER ON/OFF button to OFF position, the unit will power off.

Note: In a concern of saving energy, when playback has reached to the end or listening volume is set at a very low level and no control is operated on the device for a period of 20 minutes, the unit will automatically switch to Standby mode.

SELECTING FUNCTION

The function (BLUETOOTH/ FM/ AUX/ USB) is selected by pressing M button repeatedly.

Note: Only insert USB driver could switch into USB mode.

AUDIO CONTROLS

• Press the EQ button to set EQ (equalizers) mode as desired: FLAT (normal)/ CLAS (classic)/ rOC (rock)/ POP/ JAZZ/ LIVE/ CLUB/ DANC (dance)/ HALL/ SOFT
• REPEAT function only work in USB mode.
• MEGA BASS: It is a separated bass mode can be selected when there is audio signal.
• TONE: When there is audio signal, press this button to select treble or bass effect, then rotate the VOL knob to adjust the level as desired.

LISTENING TO THE RADIO

Manual search

1. When the unit is on, press M button repeatedly until the FM frequency appears on the display.
2. Press and hold / for step forward/rewind to search located station automatically until one station is founded, then unit will stop to search.

Automatic search and storage

Press and hold the button, the automatic search located strong station, and the unit will save the first 60 FM stations automatically. Press the button again to stop the operation. When you store on a channel already been preset, the previous station will automatically be cleared and replaced by the new station.

Note: During the search operation, the sound level is automatically muted.

Preset stations

This unit can store 60 FM stations.

Listen to station presets

1. Press / repeat the operation as many times as necessary to select your station.
2. Adjust the volume by VOL knob to the desired level.

USB PLAYBACK

You can connect a USB flash drive (not included) to the USB port on the unit to play MP3 files.

1. Insert USB driver, the unit will read USB driver and play music automatically as "USB" appear on display.
2. Press to suspend momentarily the playing track. Press again to resume playing.
3. Press button to skip to next track and to skip to previous track. Press and hold the / to search quickly within a track.
4. Press REPEAT button to select to repeat current track or repeat all tracks.

Note:

• The unit will automatically switch to USB mode and start playback when the USB flash drive is connected.
• The unit is compatible with the following Memory Device (Source): USB flash drive.
• Supporting format: MP3 (32kbps-320kbps), WMA, WAV.
• The total number of MP3 files on the Memory Device should not exceed 9999.
• There are many USB devices in the market. We cannot guarantee to support all different models. Please try another USB device if your device is not supported.

LISTENING TO AUXILIARY SOURCE

1. Connect your auxiliary source (e.g. iPod / iPad / MP3 player) to the AUX IN jack (3.5mm ).
2. When the unit is on, press the M button repeatedly until the "AUH" appears on display.
3. Start playback from your auxiliary source.
4. Adjust the volume to desired level.
5. To stop playback, disconnect your auxiliary source from the AUX jack.

Note: Button / / are not available in Aux in mode, only could control via external connected device.

USB CHARGER- A Power USB Port

Connect your device to USB cable (not included) and plug the standard USB plug into the USB charging port on the top of the unit.

Note:

• The maximum output from the USB charging port is DC 5V 1A. You can charge any rechargeable USB devices charging current less than it, such as smartphone, tablet...etc.
• Some devices may be incompatible.

BLUETOOTH PAIRING & LINKING OPERATION

1. Turn off the Bluetooth functionality of other devices that were paired with your unit.
2. When the unit is on, press M button repeatedly until "bt" appears on display.
3. On the Bluetooth device, enable Bluetooth and select "M-1932 DJ" from the Device List. (Refer to the user manual of the device to be connected for detailed operations.) If the Bluetooth device prompts for a passcode, use "0000". Some Bluetooth devices will ask you to accept the connection. If the units are paired properly, you will hear the sound "Connected".

Tip: If you want to connect your Bluetooth speaker to another Bluetooth audio device, press and hold the button to disconnect the device, and then follow the steps above to make a new connection.

Play MUSIC from Bluetooth devices

Make sure the Bluetooth connection between the unit and the device is active.

1. Press to suspend momentarily the playing track. Press again to resume playing.
2. Press button to skip forward to next track and to skip backward to previous track.

Note: / / buttons may not work with some of the players in your Bluetooth source.

SINGING THROUGH MIC JACK

1. Sing along with the music by plugging in the microphone into either one of the MIC (1/2) jacks on the unit. Rotate the MIC. VOL directly to adjust the volume as desired.
2. MIC. FIRST: Press this button to make the mic.volume louder than the music volume during singing. Press the button again to resume.
3. MIC. ECHO: Rotate this knob directly to adjust the echo intension.

Notes:

• If the microphone is placed near the loudspeaker, a howling effect (acoustic feedback) may occur. If this happens, place microphone away from the loudspeaker.
• Tapping or dropping the microphone can permanently damage your microphone. Resist the urge to swing the microphone around by the cord.

CHOOSING THE LED LIGHT MODE

To select the front light mode & speaker light mode, press the / button repeatedly to choose the mode as desired, there are 8 kinds of modes on front light and 9 kinds of modes on speaker light. Press and hold the / button to turn off the light.

TECHNICAL SPECIFICATION

POWER SUPPLY: AC100-240V ~ 50/60Hz
Radio Coverage: FM 87.5 -108.0 MHz

BLUETOOTH

Bluetooth Version: V4.2 with EDR
Bluetooth: 2.402-2.48GHz
RF Output Power: -3.602 dBm
Bluetooth working distance: Up to 10 meters measured in open space. (Wall and structures may affect range of device)

Specifications are subject to change without notice.

TROUBLE SHOOTING GUIDE

Should this unit exhibit a problem, check the following before seeking service:

No Power

• Make sure unit is connected to AC power.

No Sound – General

• External device's volume is set to minimum; raise volume.
• The M-1932DJ's volume is set to minimum; raise volume.

The Bluetooth device cannot pair or connect with the unit

• You have not activated the Bluetooth function of your device. Refer to the user manual of your device to activate Bluetooth function.
• The unit is not in pairing mode. Press and hold the button until the Bluetooth indicator blinks fast.
• The unit is already connected with another Bluetooth device; disconnect that device and then try again.

MORE INFORMATION

To reduce the risk of electric shock, do not open the device, there is no party inside for the user. Refer all servicing to qualified personnel.

The lightning with the arrow symbol in the triangle is a warning sign alerting the user to "dangerous voltage" inside the unit.

The exclamation point in the triangle is a warning sign alerting the user of important instructions accompanying the product.

The Caution mark is located at the back of the device.

• The use of apparatus in moderate climates.
• The Marking plate is located at the back of the device.
• Make sure to have a minimum distance of 5 cm around the unit for sufficient ventilation.
• Ensure that the ventilation openings is not covered with items such as newspapers, tablecloths, curtains, etc.
• Do not place naked flame sources, such as lighted candles on the apparatus.
• Do not expose this appliance to dripping or splashing water.
• Do not place objects filled with liquids, such as glass, vase on the device.
• Do not throw batteries into fire! Respect the environment when disposing of used batteries.
• Batteries should not be exposed to excessive heat such as sunshine, fire or other similar heat source.
• The power plug is used as a disconnect device and must be easily accessible. To be completely disconnected from the power, the plug of the appliance should be disconnected completely. The socket must not be obstructed and should be easily accessible during intended use.
• Under the influence of fast transient and / or electrostatic electric phenomenon, the product may malfunction and the user must perform a power reset of the device.
• The normal function of the product may be disturbed by strong Electro-Magnetic Interference. If so, simply reset the product to resume normal operation by following the instruction manual. In case the function could not resume, please use the product in other location.

If in the future, you need to get rid of this product, please note that Waste electrical products should not be disposed of with household waste. Recycling facilities exist. Check with your municipality or ask your dealer for advice. (Directive for Waste Electrical and Electronic Equipment)

The Bluetooth^® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by New One S.A.S is under license. Other trademarks and trade names are those of their respective owners.

Hereby, NEW ONE S.A.S, declares that this MUSE M-1932 DJ is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/ EU. The declaration of conformity may be consulted at www.muse-europe.com