FINAL DRIVE
INNER PLUNGING JOINT / BOOT
REPLACEMENT
1. Using a side cutters, cut away and discard the boot
clamps.
2. Remove the large end of the boot from the plunging
joint and slide the boot down the shaft.
3. Clean the grease from the face of the joint.
4. Place the drive shaft in a soft-jawed vise.
7.42
5. Using a soft-faced hammer, or brass drift, strike the
inner race of the joint to drive the joint off the drive
shaft. Be sure to tap evenly around the joint to avoid
binding.
Tap on inner race only!
6. Make sure the circlip
left in the joint.
9928485 R01 - 2017-2018 RANGER 500 / 570 Service Manual
NOTE
q
is still on the shaft and not
© Copyright Polaris Industries Inc.