Datavideo TP-700 Instruction Manual page 10

ENG & FREESTANDING TELEPROMPTER KIT
8. Fit the 15" LCD control unit, Item F, to the lower part of the ENG Prompter Frame item B using the ¼ thumb
screws, Item E. Ensure the LCD control unit has the red power button facing the front of the TP-700.
5. Slide the Glass frame, item G, on to the front of
the TP-700 ENG prompter rail, item A. Ensure the
upper part of the Glass Frame, Item G, is leaning
away from the camera position and secure with
the two wing nut screws, item H.
6. There are two slots on the inside left and right of
the Glass Frame, Item G. Guide/slide 70/30
Mirror Glass sheet, item J, into these slots from
above.
The Red circle sticker on the Mirror Glass, item
J, should be facing camera position / lens.
The Green circle sticker on item J should be
facing toward
commentator.
7. Optionally, secure the glass sheet within the frame
using the small M4 screws, Item Z, at the top of
each frame slot. The hex tool, item D2 can be
used to tighten the screws.
9. Decide if you need to use the TP-700 MKII ENG
camera riser block or not.
Ideally you want the lens of your camera
positioned as close to the centre of the 70/30
mirror glass as possible.
In some cases depending on your camera and its
ENG camera plate the camera lens may already
be high enough.
10
TP-700
the on screen talent /