Icom IC-V3500 Advanced Manual page 13

REPEATER OPERATION
2.
Reversed Duplex function
When the Reversed Duplex function is ON, the
receive frequency shifts (The transmit frequency
shifts in normal Duplex mode) An example receive
and transmit frequency are shown in the table below
with the following settings:
Input frequency: 14530 MHz
Offset direction: – (Negative)
Offset frequency: 06 MHz
Function
RX frequency 14530 MHz
TX frequency 14470 MHz
1 Push [SET LOCK] to enter the Set mode
2 Repeatedly push [SET LOCK] or [MONI ANM PA]
to select "REV" (Reverse mode)
3 Rotate [DIAL] to turn the function ON or OFF
4 Push any key other than [SET LOCK] or
[MONI ANM PA] to save and exit the Set mode
Using the HM-133V
1 Push [SET B D-OFF] to enter the Set mode
2 Repeatedly push [SET B D-OFF] or
[ENT C T-OFF] to select "REV"
3 Push [▲] or [▼] to turn the function ON or OFF.
4 Push [CLR A MW] to save and exit the Set mode
Auto Repeater function
NOTE: This function is only for the USA version
The USA version automatically activates the repeater
settings (DUP– or DUP+ and tone encoder ON/OFF)
when the operating frequency falls within the general
repeater output frequency range and deactivates them
when outside of the range
DSetting the Auto Repeater function
ON/OFF
1 Push [ ] to turn OFF the transceiver
2 While holding down [SET LOCK], hold down [ ]
for 1 second to enter the Initial Set mode
3 Repeatedly push [SET LOCK] or [MONI ANM PA]
to select "RPT" (Auto Repeater)
4 Rotate [DIAL] to select an option from "R1," "R2,"
or "OF"
• "OF": The function is OFF
• "R1": The function is ON, but the tone encoder
is OFF
• "R2": Both the function and tone encoder are
ON
5 Push [ ] to exit the Initial Set mode
OFF ON
14470 MHz
14530 MHz
DIGITAL PRIO AO BUSY
MUTE
NAR
MID
LOW
LOCK ANM
S ET MONI
The Reversed mode item
DFrequency range and offset direction
Frequency range
145200 ~ 145495 MHz
146610 ~ 146995 MHz
147000 ~ 147395 MHz
DIGITAL PRIO AO BUSY
MUTE
NAR
MID
LOW
LOCK ANM DUP T-SCAN
S ET MONI LOW TONE
The Auto Repeater item
2-5
MUTE
NAR
MID
LOW
LOCK ANM DUP
S ET
MONI LOW
The duplex icon blinks
when the function is ON
Duplex direction
A "-" is displayed
A "-" is displayed
A "+" is displayed
PRIO SCAN
M/CALL V/MHz
DIGITAL PRIO AO BUSY
T-SCAN PRIO SCAN
TONE M/CALL
V/ MHz