Before using for the first time
Programming the water
softener
To exit the programming mode at
any time, turn the dishwasher off
with the "O" button.
^ Turn the dishwasher off with "o".
^ Press and hold the "Program" and "g"
buttons simultaneously. Hold the
program button until the lower right
program indicator lights.
If it does not come on, start over.
^ Press the "Program" button twice.
The "Intake/Drain" indicator
The "Intake/Drain" indicators flashes
twice in the display.
The "SaniWash" indicator flashes once
in intervals (factory default).
^ Press the "Program" button for at
least one second, until the
"Intake/Drain" indicator lights up.
12
The amount set can be recognized by
the flashing rhythm of the "SaniWash"
indicator (see table):
°d
gr/gal
1 - 4
1 - 4
5 - 7
5 - 7
8 - 11
8 - 11
12 - 15
13 - 16
16 - 20
17 - 21
21 - 25
22 - 26
26 - 30
27 - 31
31 - 36
32 - 38
37 - 45
39 - 47
46 - 70
48 - 73
^ Select the desired setting with the
"Program" button. Every touch of the
button increases the level.
The programmed dosage is saved.
^ Turn the dishwasher off "V".
Checking the programmed water
hardness level
^ Turn the dishwasher off "V".
^ Press the "Program" button, at the
same time turn the dishwasher on "g".
Hold the "Program" button in until the
indicator lights up.
^ Press the "Program" button twice.
The amount set can be recognized by
the flashing rhythm of the "SaniWash"
indicator (see table).
^ Turn the dishwasher off "V".
Flashing rhythm
once
twice
3 times
4 times
5 times
6 times
7 times
8 times
9 times
1 long flash