Husqvarna Z246 Operator's Manual page 11

To do before you operate the
product
WARNING:
product, you must read and understand
the safety chapter.
WARNING:
product, you must make sure that there
are no stones or other objects in the
work area that can be thrown by the
rotating blades.
• Do the daily maintenance. Refer to
schedule on page 14 .
• Make sure that there is sufficient fuel in the fuel
tank.
• Set the cutting height. Refer to
height on page 12 .
To fill fuel
WARNING:
flammable. Be careful and refuel
outdoors, refer to
WARNING:
exhaust system become very hot during
operation. Risk of burn injury. Let the
engine and the exhaust system become
cool before you fill fuel in the product.
WARNING:
tank as a support area.
CAUTION:
result in engine damage.
The engine runs on gasoline with a minimum octane
rating of 91 RON (87 AKI), not mixed with oil. We
recommend biodegradable alkylate gasoline.
• Do a check of the fuel level before each use and
refuel if it is necessary.
• Do not fill the fuel tank fully. Fill to the bottom of
the fuel tank neck.
To adjust the seat
The position of the seat can be moved forward or
rearward.
Note:
Do not make adjustments to the seat when
the product is in operation.
1550 - 002 - 08.12.2022
Before you operate the
Before you operate the
Maintenance
To set the cutting
Gasoline is very
Fuel safety on page 9 .
The engine and the
Do not use the fuel
Incorrect type of fuel can
• Pull the lever below the seat up and push the
seat forward or rearward.
To fold the seat
The seat can be folded forward to get access to the
battery and hydrostatic gears.
1. Park the product on level ground.
2. Push down the latch (A) behind the seat to
release the seat.
3. Fold the seat forward until the rod (B) is
engaged.
To engage and disengage the
parking brake
This product has no dedicated parking brake lever.
The parking brake is integrated in the 2 control
levers.
• Push the 2 control levers away from the seat
at the same time to engage the parking brake.
Product overview on page 3 for the
Refer to
location of the control levers.
Note:
The product must be stationary when
you engage the parking brake.
Note:
The engine will stop if you do not push
the 2 control levers away from the seat at the
same time.
• Pull the 2 control levers in the direction of the
seat to disengage the parking brake.
B
A
11