After First 50 Hours; Engine Oil And Filter - New Holland WORKMASTER 35 Operator's Manual

After first 50 hours

Engine oil and filter

NOTE: Change the engine oil and filter after the first 50
hours of operation, then every 300 hours thereafter. If the
tractor is operated for extended periods of time at maxi-
mum rated power and speed, or under other types of con-
tinuous, severe operating conditions, the engine oil and fil-
ter should be changed at 200 hour intervals following the
initial oil change.
To change the engine oil:
1. Place a suitable container beneath the drain opening
to catch the used oil. With the tractor engine off but at
normal operating temperature, remove the drain plugs,
(1). Reinstall the plugs after all of the oil has been
drained.
NOTE: There are two drain plugs in the oil pan, one on each side of the engine.
2. Next, place a container below the oil filter, (2), to catch
the used oil and unscrew the oil filter. Discard the used
oil and filter.
3. Coat the gasket on the new filter with a film of clean oil.
Screw the filter into place until the gasket contacts its
mating surface, then turn the filter approximately three-
quarters of a turn by hand. Do not overtighten.
4. Add the proper type and level of new oil, then start the
engine and check the filter for leaks.
NOTE: Oil Capacity, with filter 6.5 l (6.9 US qt)
Recommended Oils
Ambient Temp (°F)
-12 - 49 °C (10 - 120 °F)
-23.3 - 49 °C (-10 - 120 °F)
-29 - 16 °C (-20 - 60 °F)
Oil Specification API CF-4 or CH-4
NOTE: Tractors are originally shipped with (15W40) oil.
7 - MAINTENANCE
NEW HOLLAND AMBRA MASTERGOLD™ HSP
ENGINE OIL SAE 15W-40
NEW HOLLAND AMBRA MASTERGOLD™ HSP
ENGINE OIL SAE 10W-30
NEW HOLLAND AMBRA MASTERGOLD HSP SAE
5W-30
7-9
Recommended Oil
1
NHIL12CT00696AA
2
NHIL12CT00694