Pentair SPEEDEO CONNECT Installation And User Manual page 5

USE
- DANGER - DO NOT LET CHILDREN OPERATE THIS EQUIPMENT.
- WARNING – Strictly respect the safety and handling procedures from the acid manufacturers, including protective measures for hands, body and
eyes during transferring and using acid. Follow the prescribed safety precautions for handling muriatic acid intended for checking the water pH.
Muriatic acid may cause serious physical harm and may damage the swimming pool equipment. Extra care must be taken when installing, maintaining
and operating the acid pump feed systems. Acid is dangerous to handle and should be properly contained, transported, poured, stored and dispensed.
- WARNING – Check the pH and sanitizer levels of the water before using the pool and make sure the filtration device is not obstructed.
- WARNING – Periodically use an independent pH and chlorine testing kit to ensure that the pH and chlorine is at a safe level. If the pH and Oxidation
Reduction Potential (ORP) or conductivity probes are broken, depleted or dirty with oils, lotions, or other contaminants, they can report inaccurate
results to the system causing incorrect water chemistry, which could harm people or equipment.
- WARNING – Consult the device display daily to ensure there are no alarm messages.
- DANGER – Water temperatures greater than 37.7° C (100° F) are a health hazard. Prolonged immersion in hot water may induce hyperthermia.
Hyperthermia occurs when the internal body temperature exceeds the normal temperature of 37° C (98.6 °F) by several degrees. Hyperthermia
may produce the following effects: (1) Unawareness of impending danger. (2) Failure to perceive heat. (3) Failure to recognise the need to leave the
spa. (4) Physical inability to leave the spa. (5) Harm to the foetus in pregnant women. (6) Unconsciousness leading to the risk of drowning. The use
of alcohol, drugs or medicine is a factor which increases the risk of hyperthermia in hot tubs and spas.
- WARNING - When mixing acid with water, ALWAYS ADD THE ACID TO THE WATER. Never add water to the acid. When adding a chemical product to
the swimming pool, carefully follow the manufacturer instructions.
- DANGER - DO NOT MIX SODIUM HYPOCHLORITE AND MURIATIC ACID.
- DANGER - Keep standard solutions away from children, ensure that the bottles are securely closed, store them in a dry and ventilated location
and do not let them freeze. The pH 4 calibration solution is acidic.
ELECTRICAL WIRING RULES : This product must be installed by a licensed or certified electrician or a qualified pool professional in accordance
with the local regulation depending country :
A = ÔVE 8001-4-702
B = AREI / RGIE
D = OIN VDE 0100-702
EW = EVHS-HD 384-7-702
GB = 6S7671:1992
I = CEi 64-8/7
LUX = 384-7.702 S2
NL = NEN 1010-7-702
PL = PN-IEC 60364-7-702:1999
SLO = SIST HD 384-7-702.S2
CZ = CSN 33 2000 7-702
E = UNE 20460-7-702 1993, RECBT ITC-BT-31 2002 F = NF C15-100
H = MSZ 2364-702/1994/MSZ 10-553 1/1990
IRL = Wiring Rules + IS HD 384-7-702
M =MSA HD 384-7-702.S2
P = RSIUEE
SK = STN 33 2000-7-702
TR = TS IEC 60364-7-702
All applicable local installation codes and ordinances must also be adhered to. Improper installation will create an electrical hazard which could result
in death or serious injury to pool users, installers or others due to electrical shock, and may also cause damage to power source. Always disconnect
the power to the pool light at the circuit breaker before installing or removing the light. Failure to do so could result in death or serious injury.