Prerequisites; Required Equipment; Required Tools - Pedigree Technologies OneView Cab-Mate Flex Installation Manual

Prerequisites

Required Information [*needed for final activation of hardware - see last page]
• Name of asset (ex: Propane Truck #20)
*
• Detailed information about the asset
• State, area, organization, or group the asset belongs to (ex: North Region, MN tankers, etc.)
• ESN of each device to be installed
• Current odometer reading
• Type of diagnostics connector, if possible (6 pin, 9 pin square flange, 9 pin round threaded,
J1962, Type II, etc.)

Required Equipment

LMU/Bracket

Required Tools

• Drill and assorted drill bits (ex. to mount cradle)
• Slotted, Philips, and/or Torx bits (you may need tamper resistant Torx bits)
• Panel removal tool or plastic pry bar (to remove dash panel(s) as needed)
• Small socket set
• Zip Ties (to hold cabling in place)
PedigreeTechnologies.com | Support: (701)-499-0022
(year, make, model, VIN, license plate, etc.)
*
(ESN is found on the back of each unit with a barcode)
*
Tablet
(5) #8 Self-tapping Screw 3/4 inch
(5) M4 Screw 12mm
(5) M4 Screw 8mm
(5) M4 Steel Nut
(11) M4 Star Lock Washer
(2) M4 Tamper Resistant Button Head HEX
Screw 20MM
Hardware Pack
2
INSTALLATION MANUAL
Cradle
In-Cab Readiness Kit
(booklet, stickers, DOT reference card)