Software Installation - Genmitsu Jinsoku LC-50 Plus Manual

Software Installation

Setup-LightBurn
LightBurn
Step 1: Install LightBurn and run the program.
Step 2: Connect your PC to the Control board
with the included USB cable.
Step 3: Lightburn comes with a free 30 day
trial, after this you can purchase a licence
key from SainSmart at
https://www.sainsmart.com/products/lightburn
-gcode-license-key
Step 4: Click "Find My Laser" and start to
"Device Discovery Wizard"
32
You can use the laser engraving and cutting software
Lightburn or LaserGBRL.
You can open this link or scan to get
the LightBurn GCode License Key from
SainSmart.
https://www.sainsmart.com/products/li
ghtburn-gcode-license-key
SCAN TO SHOP