Table of Contents
Advertisement
TROUBLESHOOTING GUIDE
NOTE: Always check for
Faults and Error Codes
See
figures
7
&
8
for
Component Locations.
Problem
Poor Wash Performance
Please see "Quick Start
Guide"
Troubleshooting Pinched Wires in the Harness
IMPORTANT: Verify that the harness is routed under the guides in the main control (ACU) as shown above before re-installing the console.
26
FOR SERVICE TECHNICIAN'S USE ONLY
first. Some tests will require accessing components.
For detailed troubleshooting procedures, refer to
Possible Cause
Oversuds.
Load is Tangling.
Incorrect water level.
Clothes wet after cycle is complete (not water
saturated, but very damp).
Load not rinsed.
Not cleaning clothes.
Fabric damage.
Wrong option or cycle selection.
Figure 3 - Troubleshooting pinched wires in Harness
"Troubleshooting
Checks & Tests
1. Verify use of HE detergent.
2. Excessive detergent usage.
1. Washer not loaded properly.
2. Perform Service Calibration.
1. Perform Service Calibration.
2. See
TEST #2:
Valves.
3. See
TEST #6: Water
Level.
1. Overloaded washer.
2. Oversuds (see above).
3. Items caught in tub sump.
4. Weak suspension.
5. Shifter not moving into position.
6. Cold/Rinse water > 105°F (40.5°C).
7. See
TEST #7: Drain
Pump.
8. See
TEST #3b: Drive System –
1. Check proper water supply.
2. Not using HE detergent.
3. Washer not loaded properly.
4. Shifter not moving into spin position.
5. See
TEST #2:
Valves.
6. See
TEST #3b: Drive System –
1. Washer not loaded properly.
2. Not using HE detergent.
3. Not using correct cycle.
4. Shifter not moving into position.
5. See
TEST #3b: Drive System –
1. Washer overloaded.
2. Bleach added incorrectly.
3. Sharp items in tub.
Refer customer to "Quick Reference Guide".
Tests."
Motor.
Motor.
Motor.
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the Pet Pro and is the answer not in the manual?
Questions and answers
Everytime I press start the machine says resetting. Why doesn't it just start.
The fabric softener light will not come on when i attempt to select it....
brand new machine only used 10 times and has worked great until today i **** unable to get fabric softener light to come on
The fabric softener light on the Maytag Pet Pro may not turn on because the fabric softener option needs to be manually activated. To enable it, press and hold the fabric softener button until the fabric softener light turns on. If the light still does not turn on, there may be an issue with the control board or button functionality.
This answer is automatically generated
How to do a pre soak??
To do a pre-soak with the Maytag Pet Pro, add the clothes and water, then leave the lid open. If the lid remains open, the water will drain automatically in about 10 minutes. If you close the lid, the washer will auto-drain in three hours. If you start a cycle after soaking, the washer will drain the pre-soak water and begin with fresh water.
This answer is automatically generated
What is the timing for each load feature on this machine.