Page 1
Surron official website: www.sur-ron.com Off-road electric motorcycle is used in restricted area ONLY. The actual product appearance and function may not be consistent with the contents of the manual due to technical upgrades and firmware updates. Please refer to the actual product to Please read the manual carefully before using this product.
Page 2
WARNING ・Do not ride bike into the water, otherwise it will damage the battery and motor, and even cause personal injury. ・When riding, please wear a safety helmet and obey the local traffic law and regulations. ・Do not ride when the battery compartment cap is not fully secure.
Welcome Label Position Thank you for choosing the Surron Light Bee electric off-road motorcycle. This product conforms with quality standard of Chongqing Qiulong Technology Co.,Ltd. Riding Warning Label Battery Warning Label High Voltage Warning The pictures in this manual are for reference only. Please refer to the actual appearance and functions of the bike.
●Read all additional warnings and product instructions in this Owner’s Manual as well as Requirements For Riders: (the following persons shall not ride the product) safety labels before operating your electric motorcycle. Please find an open and safe place to Ⅰ.Persons under the age of 18.
Function Diagram SPORT MODE Full power output, suitable for trail and off-road riding. Please identify the parts of the bike according to the labels in the picture and familiarize Speedometer Switch: yourself with the bike. ● Momentarily press the switch will display between current speed and total mileage to current maximum speed and current mileage.
Installation Instructions Install Front Brake and Throttle Install Handlebars 1. A s shown in the picture, after installing the throttle, roll it back 2mm. If do not turn back 2mm, it will probably 1.Use a 4# inner hexagon wrench, loose 2.Fix the front brake and throttle on the cause sluggish when rotating the throttle and remove the four screws and then take...
4. U se a 4#, 5# ihexwrenches respectively to tighten the throttle and the front brake; Note:After the cables fixed, rotate the handlebars to test and ensure that all wiring harness is tighten the throttle and then release it to ensure that it can naturally return to the loose and not strained.
Install Number Plate 3. I nstall the front wheel bushings on both sides gentaly, make sure the bushing is proper installed and all the seal are well placed, the bushing can move freely. 2. F ix the number plate on the front fork. 1....
How to Ride Install Battery 1.Open the battery box and take out the battery. Insert the key to the battery compartment 1.Insert the key into the key 2.Check if each switch, in- 3.Before starting the motor: lock and rotate counterclockwise to unlock; Open the battery compartment cap and check switch and turn on the strument, horn, brake, elec- fold up the side stand, sit...
Well Prepared Before Riding ●When riding, sudden excessive braking of the right front brake lever may lead to roll over. ●When riding, sudden excessive braking of the left rear brake lever may lead to skid. Please make sure that you have fully read all the details in p03 Chapter 1 Safety Tips and check the following items carefully.
Low Power Mode ● Battery, motor: IP65 ● Controller: IP67 ① When the battery capacity is less than 15%, the controller will reduce the output to ● Connector: IP55 protect the battery, and then the SPORT mode can no longer be used. How to Charge * The battery percentage display may be inaccurate because of the battery condition.
After using the battery for a while, if there is a space between the bottom of the battery and Please make sure to use the manufacturer’s lithium-ion battery the bottom battery compartment, you may pick up the auxiliary foam pad and stick at the charger.
4.If you want to resell or give away your Surron Light Bee off-road motorcycle, please do not forget to pass along this manual as it is part of the product. If you have any questions, please...
Troubleshooting Item Fault Cause Troubleshooting Methods 1.The connector of the charger Item Fault Cause Troubleshooting Methods 1. Insert the plug or connector firmly to is loose or disconnected open the battery compartment cap Charger not 1.The battery cable is loose 2.The connector of the battery 2.
3.If there is any abnormality during the inspection, please rectify the abnormality before should be 40 N·m, The front axle screw locking torque depend on the front fork. riding. If the problem is difficult for you to solve, please contact Surron or the local authorized CAUTION dealer.
Need help?
Do you have a question about the Light Bee QL3000DY and is the answer not in the manual?
Questions and answers