GenInterlock SIE-L2 Instructions

Model
Description
Main Breaker
Generator Breaker
Only qualified personnel should be working on the panel box
An amateur should NEVER open the panel box
Please follow all rules and regulations of the National Electric Code
Step 1: Disassemble the interlock. Place the bottom plate (holes only) from edge of main breaker to bottom edge of generator breaker
Step 2: Turn off main breaker and remove panel cover.
Step 3: Drill holes as marked on panel cover with supplied 3/16 drill bit and remove all burs from drilling cover.
Step 4: Insert screws from rear of cover, install bottom plate, and install top plate (slotted) install retaining nuts, and thread lock. And
Ensure proper movement.
Step 5: Install 2 pole Generator breaker on top right side and place Generator Warning Sticker on Generator breaker.
Step 6: Combine 2 zip ties and install zip tie under metal plate and around top of breaker as shown in picture below. Pull on ends to
make tight around breaker and trim ties as needed. Install warning label on zip ties next to breaker.
SIE-L2
Generator Interlock Kit for Siemens Left column Main 150-200 Amp
150 or 200 amp single handle Horizontal throw Right (on) Left (off)
Top right side 2 positions
WARNING