Download
Share
Print this page
  1. Manuals
  2. Brands
  3. Weda Manuals
  4. Lighting Equipment
  5. B600
  6. Service manual

Weda B600 Service Manual

Hide thumbs

Advertisement

Quick Links

Download this manual
B600
Service Manual
WEDA
WEDA
Tel: +46 8 550 325 50
Tel: +46 8 550 325 50
Wedavägen 4A
Wedavägen 4A
Fax:+46 8 550 310 50
Fax:+46 8 550 310 50
152 42 Södertälje Sweden
152 42 Södertälje Sweden
Email: info@weda.se
Email: info@weda.se
www.weda.se
www.weda.se
underwater
cleaning
technology
20180905

Advertisement

loading
Need help?

Need help?

Do you have a question about the B600 and is the answer not in the manual?

Questions and answers

Summary of Contents for Weda B600

  • Page 1 B600 Service Manual WEDA WEDA Tel: +46 8 550 325 50 Tel: +46 8 550 325 50 Wedavägen 4A Wedavägen 4A Fax:+46 8 550 310 50 Fax:+46 8 550 310 50 152 42 Södertälje Sweden 152 42 Södertälje Sweden Email: info@weda.se...
  • Page 2 B600 Service Manual Standart equipment Technical specification B600 Cleaning unit Trolley and safety transformer Installation and maintenance Dataplate and signs Remote control and Start Up display On/Off Switch Immersion in the pool Running the cleaner Manual and automatic mode Vertical wall cleaning...
  • Page 3 B600 Service Manual Standart equipment Cleaner with floating cover and 40 m floating cable Filter system Trolley with safety transformer 2. Technical specifications B600 Manufactured in accordance with 89/392/EEC and EN60-335-1 plus EN60-204 for remaining parts. 2.1 The cleaning unit Dimension, L*W*H (mm) 860x600x300 mm Weight in air approx.

  • Page 4: Remote Control

    B600 Service Manual 3. Instalation and maintenance 3.1 Dataplate and signs Read the information on the dataplate on the safety transformer box . The connected primary voltage can be checked after removal of the top cover of the safety transformer.
  • Page 5 B600 Service Manual 4. Immersion in the pool Make sure no-one is in the pool. Drive the trolley to the poolside , to a point at the middle of the longside of the pool. Stop at least 2 meters away of the side of the pool. ( 3,5 meter in the UK ) Lock the rear wheels of the trolley.
  • Page 6 B600 Service Manual 5.2 Vertical surface cleaning Prepare the cleaner by moving the rubber strips (at the front and back edge ot the bottom plate) to the lower position . Drive the cleaner in the pool towards the wall to be cleaned.
  • Page 7 B600 Service Manual 7. Adjustments 7. 1 Bumper bar sensors Release the screw that holds the sensor . Press the bumper bar all the way in. Make sure that the sensor touches the bumper bar bottom when fully depressed. Lock the sensor screw. Let the sensor bar go back to its resting position.
  • Page 8 B600 Service Manual Drive track tension The drive track tension can be adjusted by moving the rear wheel forwards or backwards. Release the shaft slightly, adjust with the adjusting screws. The drive track should have a play according to the picture.
  • Page 9 Do not overfill, excessive grease will be forced out. 8.3 S pecifications. For grease gun : Weda Poolcleaners white non toxic special grease WP Nº 740 388. For screw gear : oil API GL4 75W90, 100 cc WP Nº 740 209 .
  • Page 10 Service Manual 9 Important Do not use the cleaner for period longer than 10 minutes out of water. Use only Weda Poolcleaner original spare parts. Max. test presure inside machine 0,5 bar. Do not pull the unit by the power cable.

  • Page 11: Troubleshooting

    Switch breaker on Power Control Box 4 Over current relay set too low Increase in steps by 0,2 5.Water inside the pump Contact Weda service The cleaner does not move 1. Magnetic clutch switch off Check the switch but the drive motor runs 2.