Chapter
Configuration
3
This chapter provides general information for configuring a VersaMax PNS and its IO modules
in a PROFINET-IO network. For information on configuring the PROFINET IO-Controller and its
network, refer to the IO-Controller manufacturer's documentation.
Note: To configure a VersaMax PNS in an RX3i Controller system, refer to the PACSystems
RX3i PROFINET Controller Manual, GFK-2571.
This chapter discusses the following topics:
▪
Configuration Overview
o Basic Configuration Steps
o Configuration Tool
▪
Adding a VersaMax PROFINET Scanner to a LAN
o Configuring VersaMax PROFINET Scanner Parameters
o Adding VersaMax PROFINET Scanner Power Supplies
o Adding VersaMax Modules to a Remote Node
o Adding Power Supplies Between Modules
o Configuring VersaMax Module Parameters
o Configuring Analog Modules that have Jumpers
▪
Assigning IO-Device Names
▪
After the Configuration is Stored to the PROFINET IO-Controller
▪
Clearing the PROFINET IO-Controller Configuration
▪
Replacing PROFINET Scanner Hardware
GFK-2721A
3-1