Page 1
PoE. We recommend that you protect your networks from harmful outdoor environments and destructive ESD events with industrial-grade, shielded Ethernet cable from Ubiquiti.. For more details, visit ui.com/toughcable Surge protection should be used for all outdoor installations. We recommend that you use two Ethernet Surge Protectors, model ETH-SP, one near the B-DB-AC and the other at the entry point to the building.
BulletM2-HP Quick Start Guide Hardware Overview Signal LEDs In airOS®, you can modify the threshold values for the wireless signal strength LEDs on the Advanced tab under Signal LED Thresholds. The default values are shown below:...
BulletM2-HP Quick Start Guide Ethernet LED The Ethernet LED will light steady green when an active Ethernet connection is made and flash when there is activity. Power LED The Power LED will light green when the device is connected to a power source. Reset Button To reset to factory defaults, press and hold the Reset button for more than 10 seconds while the device is powered on.
Page 6
BulletM2-HP Quick Start Guide Accessing airOS Verify connectivity in the airOS® Configuration Interface. 1. Make sure that your host machine is connected via Ethernet to the device. 2. Configure the Ethernet adapter on your host system with a static IP address on the 192.168.1.x subnet.
You can also manage your device using the Ubiquiti Network Management System. BulletM2-HP Quick Start Guide Setup using the UISP™ app requires the U-Installer, sold separately. Installer Compliance Responsibility Devices must be professionally installed and it is the professional installer’s responsibility to make sure the device is operated within local country regulatory requirements.
BulletM2-HP BulletM2-HP Quick Start Guide Output Power 25 dBm Power Supply AC to 24VDC, 0.5A Gigabit PoE Adapter Power Method 24V Passive PoE (Pairs 4, 5+; 7, 8-) ESD/EMP Protection ± 24 kV Contact/Air Operating Temperature -40 to 70° C (-40 to 158° F) Operating Humidity 5 to 95% Condensing Shock and Vibration...
Page 9
BulletM2-HP Quick Start Guide Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions.
Page 10
This equipment complies with radiation exposure limits set forth for an uncontrolled BulletM2-HP Quick Start Guide environment. This equipment should be installed and operated with minimum distance 20 cm between the radiator and your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
Need help?
Do you have a question about the BULLETM2-HP-US and is the answer not in the manual?
Questions and answers