Verify Upgrade; To Verify Baseboard Version - Honeywell CIPer 30 Installation And Operation Manual

CIPer TM MODEL 30 CONTROLLER - INSTALLATION AND OPERATIONS GUIDE

Verify Upgrade

After the upgrade process of the CIPer Model 30 controller and Expansion IO, verify the versions of
QNX/Baseboard Firmware/Software Tool.
Log in to the Platform of the controller and then go to Platform Administration, and verify the updated versions
installed. Refer to the below image, highlighting installed versions on the controller.

To Verify Baseboard Version

1. Go to Application Director and start the station. Wait for the station to start when the station status
displays running
2. Log in to the station.
If you are logging into the station the first time, then use default credentials.
•
Username: admin
•
Password: Honeywell1
The change password wizard will come up to change the default credentials.
3. Navigate to Station > Drivers > IPCNetwork and click on localDevice.
This action opens the local device property sheet. Verify the updated firmware details. Refer to the below
image, highlighting installed firmware versions on CIPer Model 30 controller and Expansion IO.
31-00206 - 02 22