SOMFY F-74300 CLUSES Instructions

Table of Contents

Contents

1 OVERVIEW
2 SAFETY
3 TECHNICAL DATA
4 PAIRING
5 RESTORING THE ORIGINAL CONFIGURATION
6 TROUBLESHOOTING
7 Documents / Resources
- 7.1 References
- 7.2 Download manual

OVERVIEW

Overview

On/Off, pairing & LED

SAFETY

Before installing and using this product, please read these instructions carefully. Any use outside the field of application specified by Somfy is forbidden. This invalidates the warranty and discharges Somfy of all liability, as does any failure to comply with the instructions given herein. Never begin installing without first checking the compatibility of this product with the associated equipment and accessories.

Keep out of reach of children.

To avoid damaging the product:

Do not drop the device. Avoid splashes. impacts.
Protect it from liquid
Do not immerse it in water.
Do not open it.

Damaged electrical or electronic products, such as used batteries, should not be disposed of with household waste. Please take them to a collection point or an approved centre to ensure they are recycled correctly.

TECHNICAL DATA

Power supply: 220 - 240 V 50 Hz

Radio frequency: 868.42 MHz.

Frequency bands and maximum power used: 868.42MHz e.r.p <25 mW

Radio range: 30 m

Protection rating: IP20.

Operating temperature: 0°C to +40°C.

Size: 74 mm x 52 mm x 52 mm

Max. switched power: resistive 1500 W, incandescent 800 W, fluorescent 200 W, LED 200 W

PAIRING

A pairing procedure must be carried out to associate the Zwave On/Off Plug and the Somfy Home Automation Box.

Connect the "Zwave On/Off Plug".
Connect the "Zwave USB Dongle" to the Somfy Home Automation Box.
On the interface of the Somfy Home Automation Box, select the Configuration mode represented by the gear symbol.
- Click on the "Zwave" button
- Click on the "Add" button
- Check that your plug is powered.
- Click on Continue
- Briefly press the On/Off button three times within a two-second interval
- Follow the procedure shown on the screen.
Once paired with the Somfy Home Automation Box, the "Zwave On/Off Plug" can be controlled via the interface of the Somfy Home Automation Box.

The On/Off function can be controlled manually by briefly pressing the "On/Off & pairing" button.

RESTORING THE ORIGINAL CONFIGURATION

To reset the Zwave On/Off Plug, briefly press the On/Off button three times then press and hold until the LED starts flashing.

TROUBLESHOOTING

Fault detected	Action	Result	Possible causes
The product does not work when operated by the Somfy Home Automation Box.	Test by pressing the plug's On/Off button. Depending on the result, go to "a" or "b".	The product does not work.	The product is damaged or wired incorrectly.
		The product works.	Check the status of the LED (1). If it is flashing, the product is not paired. Repeat the pairing procedure. If it is not flashing, perform a reset then the pairing procedure.