Xfinity Voice Remote Manual

Table of Contents

Contents

1 Meet Your Remote
2 Turn On Your Remote
3 Pair Your Remote for Voice Control
4 Troubleshooting
5 FCC Compliance Statement
6 Documents / Resources
- 6.1 References
- 6.2 Download manual

Meet Your Remote

Turn On Your Remote

Your remote arrives with the AA battteries already installed, but not activated. Here is how to power it onn for the first time.

Pick up your remote and remove Pick up your remote and remove the "Pull" tab on the back by the "Pull" tab on the back by pulling up on the tab. The Status pulling up on the tab. The Status LED will blink green four times LED will blink green four times as the remote powers up (about 5 as the remote powers up (about 5 seconds). seconds).
Make sure your TV and set-top Make sure your TV and set-top box are turned on. box are turned on.

Pair Your Remote for Voice Control

Use Voice Control to search for networks and shows, set DVR recordings, and get recommendations.

Press and hold the Xfinity button and Info button until the status LED changes from red to green (about 5 seconds).
You should see the an on-screen confirmation when the remote is paired. If you do not see confirmation, press the Xfinity button again.
Once your remote is paired, follow the on-screen instructions to set up power, volume, and input control for your TV.
Now that your remote is set up, press and hold the Voice button to ask "what can i say?" for some voice command suggestions.

Troubleshooting

Remote not working with your TV?
The remote has to be programmed to the TV and/or audio receiver to control power, volume, and input. Go to the Remote Settings screen on X1 to program control of your TV and audio receiver.

Need help?
Say "Remote help" to see tips & tricks for using your remote.

Voice command not working?
Make sure you're pressing the Voice button while you speak into the remote, and release it when complete.

Need to pair with another box?
If you want to use your remote with a different set-top box repeat step 3 while pointing the remote at the box.

Looking for more information?
Visit Xfinity.com/remotes for additional help with Xfinity remotes

FCC Compliance Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not used in accordance with the instructions, may cause harmful interference to radio communications.

There is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase or decrease the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that which the receiver is connected.
Consult the dealer or an experienced remote control / TV technician for help.
It is strongly recommended that the TV be plugged into a separate wall outlet.

The user is cautioned that changes and modifications made to this equipment without the approval of the manufacturer could void the user's authority to operate this equipment.
This device complies with part 15 of the FCC rules.
Operation is subject to the following two conditions:

This device may not cause harmful interference, and
this device must accept any interference received, including interference that may cause undesired operation.