Pairing And Connecting A Bluetooth Enabled Conference Phone; Testing The Bluetooth Enabled Conference Phone; Using A Bluetooth Hands-Free Device - Atos Unify OpenScape CP710 User Manual

123
Answer
Pairing and connecting a Bluetooth enabled
conference phone
Below is an example of pairing, connecting, and testing the conference
phone "Konftel 60W".
Prerequisite: Bluetooth is enabled on the phone (see
Bluetooth" à page 128). The conference phone is ready for use but
switched off.
Finding and pairing the conference phone
Hold down the trim key on the conference phone for two seconds until
the blue display lights flash.
Pairing and connecting a Bluetooth enabled conference phone requires
the same pairing and connecting procedure for all Bluetooth devices:
Enable Bluetooth pairing mode on the conference phone (see the
l
user manual supplied with the device).
Start pairing the conference phone (see
l
à page 117)
After successfully pairing the conference phone , connect it with the
l
OpenScape Desk Phone CP710 (see
Bluetooth device" à page

Testing the Bluetooth enabled conference phone

Prerequisite: The conference phone is ready for use but switched off.
The OpenScape Desk Phone CP710 is in idle mode.
Both the phone and the conference phone ring. The caller is displayed. To
answer the call, you have the following options:
Press the key shown.
l
Select "Answer".
l
Press the On-Off key on the conference phone.
l
You are connected with the other party. The conference phone is activ-
ated. You can initiate a consultation call or accept a second call to set up a
conference.

Using a Bluetooth hands-free device

You can control calls on the HFAG (hands-free audio gateway, e.g. mobile
device) from the phone via Bluetooth.
"Pairing Bluetooth devices"
"Connecting or disconnecting a
118)
Using Bluetooth
"Activating