Assembly; Operation - Husqvarna HA322 Operator's Manual

• Always wear heavy-duty gloves when repairing the
cutting attachment. This is extremely sharp and can
easily cause cuts.
To install the harness support hook
1. Install the harness support hook between the loop
handle and the throttle handle.
To do a check before start
1. Examine the work area. Remove any objects that
could be thrown out.
2. Examine the cutting attachment. Do not use blades
that are damaged.
3. Examine that the product is in perfect working order.
Examine that all nuts and screws are tight.
4. Make sure the gear housing is lubricated correctly.
See To lubricate the transmission housing and gear
housing on page 9 for instructions.
5. Examine that the cutting attachment stops when the
throttle/power trigger is released.
6. Only use the product for the purpose it was intended
for.
7. Make sure that the handle and safety features are in
good working order. Never use a product that lacks a
part or has been modified outside its specifications.
1917 - 001 - 18.07.2022
• Store the product out of reach of children.
• Use only original spare parts for repairs.

Assembly

Note:
Do not put the support hook on the decal.
2. Tighten the 2 screws with the hex key.
3. Adjust the ring to make the product balanced, and
easy to use.

Operation

To operate the product
1. Work with a swinging action from the bottom
upwards when trimming sides.
2. Adjust the throttle/speed setting to suit the load.
3. When you use a gasoline operated product to cut a
hedge, make sure the engine faces away from the
hedge.
4. Do not rush the work, but work steadily until all the
branches have been cut back cleanly.
To change the hedge trimmer angle
1. Stop the product.
7