Sorotec ALU 0605 Assembly Instructions Manual page 30

Assembly Instructions
Alu-Line
• Tighten the fastening screws motor plate Z
plate Z-axis . Tightening torque: 6 Nm
32
• Move the guide plate Z
towards the motor plate Z by turning the ball
screw.
• Tighten the fixing screws
bearing unit. Tightening torque: 6 Nm
• Place the insulation foil between the reference
switch and the Z reinforcement
39
screw on the reference switch as shown in Fig.
39.
• Screw the complete Z-axis assembly to the Y
guide plate with cylinder screws M6x16
slightly counter-tighten the screws.
For alignment, a dial gauge must be attached to the
moving part of the Z-axis and a stop bracket must be
attached to the base frame. Turning the ball screw of
the Z-axis moves it up and down (see figure 40).
• Align the Z-axis on the guide plate Y in such a
way that the dial gauge does not deflect when
the Z-axis moves up and down. In this position,
tighten the fastening screws
torque: 10 Nm.
www.sorotec.de
31
as far as possible
10
of the fixed
C3
and
55
;
D2
. Tightening
D2
Page 29/33
/
Fig. 40: Aligning the Z axis
D2
D2
V 2.0.0