Remote; Remote Update; Smartgrid - Miele PDR 914 Operating And Installation Instructions

The machines are in a network with internet connection. All machines are configured as
slaves. Data is synchronised over the internet.

Remote

Programmes are selected on an external terminal.
Factory setting: Off

Remote Update

The RemoteUpdate function is used for updating the software in your tumble dryer.
The RemoteUpdate function is deactivated as standard.
If you do not install a RemoteUpdate, you can continue to use your tumble dryer in the
usual way. However, Miele recommends installing RemoteUpdates.
The RemoteUpdate menu option is only displayed and can only be selected if you have
added your tumble dryer to your Wi-Fi network.
Miele's RemoteUpdate function can only be used if the tumble dryer is connected to a Wi-
Fi network and you have an account in the Miele Professional App. The tumble dryer must
be registered in the app.
See the Miele Professional App for terms and conditions of use.
Some software updates can only be carried out by a Miele service technician.
If a RemoteUpdate is available for your tumble dryer, it will be displayed automatically
when the Supervisor level is open.
You can choose to start the RemoteUpdate immediately or wait until later. If you select
"Start later", the prompt to run the RemoteUpdate will be displayed again the next time you
switch on the dryer.
The RemoteUpdate can take several minutes.
Please note the following information about the RemoteUpdate function:
- You will only receive a message when a RemoteUpdate is available.
- Once a RemoteUpdate has been installed, it cannot be undone.
- Do not switch off the tumble dryer during a RemoteUpdate. Otherwise, the
RemoteUpdate will be aborted and will not be installed.

SmartGrid

SmartGrid
The setting (available depending on country) is only visible if a Wi-Fi network is
set up and activated. This function can be used for starting your Miele Professional
machine automatically at a time when your energy supplier's electricity tariffs are most
economical.
SmartGrid
Activating
SmartStart. The tumble dryer will then start within the timeframe specified when it receives
a signal from the energy supplier. If it has not received a signal from the energy supplier by
the latest start time set, the tumble dryer will start automatically.
Factory default setting: Off
Timer
gives the sensor a new function. Use the
Supervisor level
Timer
sensor to set
51