Sealey HT102R Quick Start Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to
instructions
1. SafETy
1.1. General
do noT shine directly into your, another person's or an animal's eyes.
8
do noT allow children to use the torch.
8
do noT use the torch if you suspect that the battery or the torch casing is damaged.
8
do noT leave batteries in a discharged state. Before storage remove batteries.
8
Battery Safety
1.2.
WaRninG! To reduce the risk of burns or fire:
‰
do noT attempt to open the batteries.
8
do noT crush, puncture, short contacts or dispose of in fire or water.
8
do noT expose to temperatures above 60°C (140°).
8
Replace only with the batteries designed for this product.
9
Recycle or dispose of used batteries as stipulated by local regulation.
9
If the electrolyte in the batteries gets on your skin, thoroughly wash with soap and water. If it gets in your eyes, rinse thoroughly
9
with cool water and seek immediate medical attention.
2. inTRodUCTion
Hands-free head torch with adjustable 3W CRee XPe led spotlight to direct light as required. one switch features an auto sensor to activate
light with the wave of a hand and standard on/off switch. Produces up to 120 lumens. Other switch has three power options of full, 30% energy
saving mode, flash and red light. Powered by a rechargeable 3.7V 1.2Ah Li-ion battery. Supplied with micro USB charging lead.
3. SpECifiCaTion
Model no: .................................................................HT102R
led Qty: ........................................................3W CRee XPe
lumen output: ............................................................. 120lm
Battery: .......................................................3.7V 1.2Ah Li-ion
Charging Time: ..................................................................4hr
nett Weight: ..................................................................... 84g
4. opERaTion
4.1. Charging: Connect the USB lead to the port on the bottom of the head torch (fig.2). The LED indicator will show red whilst the battery
is charging and green when the battery is fully charged (fig.3).
4.2. Main Beam: Press on/off switch once for full beam, twice for a dipped beam, third time for flashing and forth to turn off.
4.3. Red lights: Holding down the on/off switch for 3 seconds will turn on the red lights
4.4. Motion Activated Light: Press the motion sensor button to enable this function. A blue light will show on top of the torch when the
sensor is activated. You will now be able to turn the torch on and off by waving your hand in front of the sensor.
fig.2
© Jack Sealey Limited
3W CREE USB HEad ToRCH WiTH SEnSoR
HT102R
Model no:
Original Language Version
fig.1
fig.3
HT102R | Issue 1 03/05/18