Setting Modem Defaults - Moxa Technologies oncell G2100 Series User Manual

OnCell G2100 SeriesI User's Manual

Setting Modem Defaults

The following instructions illustrate how to use Configurator to load the factory default settings
into the OnCell G2100 Series modem.
1. Connect the RS-232 port of the OnCell G2100 Series modem to a host PC. On the OnCell
G2150I, make sure the RS-232 port is connected and DIP switch 1 is set to ON.
ATTENTION
The RS-232 connector uses the standard pinouts. A direct male DB9 to female DB9 cable, such as
Moxa's CBL-F9M9-150 (100 cm) or CBL-F9M9-20 (20 cm), can be used to connect to a PC's
serial port. If you use a USB-to-serial product to configure the OnCell G2100 Series modem, we
strongly recommend using Moxa's UPort 1110. Other USB-to-serial products may cause
unexpected errors when configuring the OnCell G2100 Series modem.
2. Start OnCell Configurator and select the Create a new Configuration File from
Configurator option.
3-36
OnCell Configurator