Advertisement
Suite 26/42 Bundall Rd, Bundall QLD 4217
PO BOX 684 Surfers Paradise, QLD 4217
Ph: 07)5600 0821 Freecall: 1800 KEYPRO
sales@ksq.com.au
www.ksq.com.au
HOW TO CHANGE THE CR2450 LITHIUM BATTERY FOR ALL MINIK10 LOCKER LOCKS
The below instructions are to be used as a guide to help rectify some faults within the Minik10 Locker locks
due to in-proper installation, incorrect programming or over tightening of the locks.
The first step is to remove the lock from the door. To do this, remove the hex nut off the back of the barrel,
carefully storing the mounting accessories in safe area to ensure they are not lost. Remove the lock from
the locker door and place it on a soft surface with the keypad facing down.
The second step is to change the locks battery.
Using a small Philips head screwdriver, remove the small screw holding in the back-battery tab.
Once this is removed, use a flat head screwdriver to carefully pry the battery out of the lock.
KeyWatcher & KeyWatcher Touch Electronic Key Management
Systems ● Tamper Proof & Tamper Evident Security Key Rings
& Key Seals ● Security Key Lock Boxes ● Automatic Key Dispensers
● Australia and SE Asia Distributor for MiniK10 Digital RFID Locker &
Cabinet Locks ● Qld Security Master License No: 3459992
Neaves Investment Group T/A Keywatch Systems Qld
ABN 61 102 798 381
Advertisement
Table of Contents
Related Manuals for KSQ CR2450
Summary of Contents for KSQ CR2450
- Page 1 Neaves Investment Group T/A Keywatch Systems Qld ABN 61 102 798 381 HOW TO CHANGE THE CR2450 LITHIUM BATTERY FOR ALL MINIK10 LOCKER LOCKS The below instructions are to be used as a guide to help rectify some faults within the Minik10 Locker locks due to in-proper installation, incorrect programming or over tightening of the locks.
- Page 2 Replace the old battery with the new battery and ensure you dispose of the old battery correctly. Please note, the battery must be installed with the flat, positive side facing up as per below. Carefully insert the back-battery tab and fasten the small screw to secure the battery tab back in place. Once you have re-installed the battery, test the operation of the lock prior to re-installing it on the locker.
Need help?
Do you have a question about the CR2450 and is the answer not in the manual?
Questions and answers