Acer VG272U Manual page 11

Preparation before assemble:
1.Clean the room for work
2.Identify the area for material
Prepare the implement, equipment, materials as bellow：
3.
1) working table
2) Screw-driver
3) Knife
4) glove
5) cleaning cloth
6) ESD protection
Step 1
Step 2
Step 3
Pic 1
S2
Assemble the MF and panel
4.2 Assembly Procedures
Insert lamp wire & panel edp to the Main BD.
Connect LVDS to Main BD and Power BD
Put the SHD on the worktable.
Locate Main BD and Power BD into the SHD.
Cover the mylar on Power BD
Lock 6 screws as the picture sequence.
Assemble navi key and FFC LED to the PCBA key BD as the picture
1.
Assemble the key BD on rear cover.
Lock two screws to the rear cover as below pic 2.
Fix the wire of speaker by yellow tape as below pic 3.
Take the Panel on the sponge cushion.
Insert the little connector of the lamp wire to panel as the picture 1, thread the lamp
wire out of the hole of the MF. Assemble the MF onto the panel.
Lock 9 screws to the MF as the picture 2.
Insert the FFC wire to the Panel as the picture 3.
短的蓝色
补强板端
插按键板
长的蓝色补
强板端插主
板