3 Use your TV
Switching on your TV and putting it in
standby mode
TV
Remote Control
To turn the TV on from standby or off to standby
•
Press
on the TV or the remote control.
Note(s)
•
Energy consumption contributes to air and water pollution. When the AC power cord is plugged
in, your TV consumes energy with a very low standby power consumption.
Adjusting volume
TV
Remote Control
To decrease or increase volume
•
Press VOL
/
on the TV or press VOL + / – on the remote control.
(–) : Volume down
VOL
VOL
(+) : Volume up
To mute or unmute sound
•
Press
on the remote control to mute the sound.
•
Press
again or VOL + / – to recover the original sound.
Switching channels
TV
Remote Control
To select channels by using CH
•
Press CH
(up) /
down) on the TV or press CH + / – on the remote
control.
To select channels by using the NUMBER buttons
Digital TV operation
•
For digital channels, press a number followed by a dot "•" and the
corresponding sub channel number.
–When selecting digital channel 1 1. 1
Be sure to press • before entering the subchannel number.
Cable / NTSC (Analog) TV operation
–When selecting cable or analog channel 1 1
Press PREV.CH to return to the previously viewed channel.
Note(s)
•
To select the non-memorized channels, use the NUMBER buttons.
•
Channel not available or No signal will appear on the TV screen after the subchannel broadcast
is over.
•
Audio only message will appear on the TV screen, when you receive only sound signal.
19
/
or CH + / –
Continued on next page.
.
English