Operation Information - DESKHAUS APEX PRO/4 Product Assembly Instructions

OPERATION INFORMATION

HEIGHT CALIBRATION
1. Hold the down button/direction (SmartPaddle) on the handset until the desk reaches
its lowest height, then release.
2. Measure the height from the floor to the top of your desktop. If the displayed height
does not match your measurement, follow the next steps.
3. Hold the down button/direction (SmartPaddle) again until the LED display reads "Reset".
4. Press the "M" or side button (SmartPaddle) until the numeric display begins flashing.
5. Press Up or Down until the read out matches your measurement.
6. Wait for the display to return to "Reset", hold the down button/direction
(SmartPaddle) until the desktop lowers slightly and rises slightly and the display
changes back to the numeric height setting, then release.
Note: When using your handset for the first time, you may need to reset the handset if the display shows
"Reset" to ensure that it is properly calibrated. To reset the handset, keep pressing the paddle down to
the lowest height and release. Then press the paddle down again for 5 seconds until the display shows
"Reset" and returns back to a normal digital number to finish the reset. Your handset is now ready to use.
RAISING THE TABLE
Hold the paddle up and the height adjustable desk will rise. Release the paddle and it will stop.
LOWERING THE TABLE
Hold the paddle down and the height adjustable desk will lower. Release the paddle and it will stop.
USING THE MEMORY FUNCTION
Setting the memory for seated height
Adjust the desk to your preference below 35.5 inches (seated height). Press the side button on
the handset once and the ♥ will show on the display. Press the side button one more time to
save the current height. The display should show ♥ -2
Setting the memory for standing height
Adjust the desk to your preference above 35.5 inches (standing height). Press the side button on the
handset once and the ♥ will show on the display. Press the side button one more time to save the
current height. The display should show ♥ -1
APEX PRO/4