Identifying Monitor Conditions - HP ENVY 27 User Manual

Icon
?

Identifying Monitor Conditions

Special messages appear on the monitor screen for the following monitor conditions:
• Monitor Status — When the monitor is powered on or when the input source signal is
changed, a Monitor Status message appears for 5 seconds. The message shows which input
is the current active signal, the status of the auto-switch source setting (On or Off), the default
source signal, the current preset display resolution, and the recommended preset display
resolution.
• Input Signal Out of Range — Indicates the monitor does not support the video card's input
signal because its resolution or refresh rate are set higher than the monitor supports. Change
your video card settings to a lower resolution or refresh rate. Restart your computer for the
new settings to take effect.
• Power Button Lockout — Indicates the power button is locked. If the power button is locked,
the warning message Power Button Lockout appears. If the power button is locked, press
and hold the power button for 10 seconds to unlock the power button function. If the power
button is unlocked, press and hold the power button for 10 seconds to lock out the power
button function.
20 Chapter 4 Operating the Monitor
Main Menu Options Sub-menu Options
Serial Number
FW Version
Backlight Hours
Service Support
Factory Reset
Source Control
DisplayPort
HDMI
VGA
Default Source
Auto Switch Source
Source Detection
Exit
Description
Reports the serial number of the monitor. The
serial number is needed if contacting HP
technical support.
Reports the firmware version of the monitor.
Reports the total hours of backlight operation.
For service support, see the HP Technical
Support website at http://www.hp.com/support.
Returns settings to factory defaults.
Selects the video input signal. The factory
default by priority is DisplayPort, HDMI, and
then VGA.
Selects DisplayPort as the video input signal.
Selects HDMI as the video input signal.
Selects VGA as the video input signal.
Selects the default or primary video input
signal when the monitor is connected to two
active and valid video sources. The monitor
automatically determines the video format.
Turns the system's automatic video signal
input to On or Off. The factory default is On.
This option is displayed in the OSD when a
DisplayPort input is selected. You can set
Source Detection to :
•
Always Active
•
Low Power
The factory default is Low Power.
Exits the OSD menu screen.
ENWW