Installing A Printer Driver - Lexmark T630 Setup Manual

Installing a printer driver

Setting parameters
in the communications
(COM) port
– Stop Bits must be set to 2.
– Flow Control recommended protocol setting is Xon/Xoff.
5
Press Return to exit the menus when finished.
6
Print a Menu Settings page and verify that your serial
parameters are correct. Keep this page for later use.
a
Press Menu until you see Utilities, and then press Select.
b
Press Menu until you see Print Menus, and then press
Select.
c
Look under the Standard Serial (or Serial Option X if you
installed a serial interface card) heading to find the serial
parameters.
You must install a printer driver on the computer that is connected to
the printer.
1
Insert the drivers CD. If the CD does not launch automatically,
click Start Run, and then type the following in the Run dialog
box:
D:/Setup.exe.
2
Click Install Printer Software.
3
Click Agree if you accept the Printer Software License
Agreement.
4
Select Local printer install, and then click Next.
5
Check the box next to the printer you are installing, and then
select the communications port (COM1 or COM2) you want to
use.
6
Click Finish to complete the printer software installation.
After the printer driver is installed, you must set the serial parameters
in the communications port assigned to the printer driver.
Install drivers for local printing
52