Manual Measurements; Figure 6-7: Peripheral Scheduler; Figure 6-8: Start A Manual Measurement; Figure 6-9: Stop A Measurement - GE Kelman MINITRANS User Manual

6.1.1.4 Peripheral Scheduler
An information notice lists all peripheral connections as shown in Figure 6—7. If the
peripheral scheduler is enabled, all analogue inputs are listed with corresponding null
values. The product has analogue inputs AIn1 to AIn6, but corresponding values for these
appear after peripheral(s) are connected. By default, a newly shipped product has no
connected peripherals, but a configured installation may have a load sensor connected.
PERIPHERAL SCHEDULER
STANDBY
>>> OK <<<
MAIN
>>> OK <<<
Figure 6—7: Peripheral scheduler
6.1.2

Manual measurements

6.1.2.1 Start a manual measurement
Use TransConnect to start a manual measurement on the main tank. The timer
automatically counts down from 10 seconds and indicates that a manual measurement
is about to proceed. Figure 6—8 shows the relevant screens.
MAIN
MEASUREMENT IN
10 s
2013-07-30 11:21:00
MAIN
MEASUREMENT STARTED
2013-07-30 11:21:10
MAIN
>>> OK <<<
Figure 6—8: Start a manual measurement
6.1.2.2 Stop a measurement
Use TransConnect to stop an active measurement. After any remaining oil in the
headspace drains, the product returns to Standby mode as shown in Figure 6—9.
2013-07-30 11:45:00
OIL DRAINING
2013-07-30 12:00:00
STANDBY
Figure 6—9: Stop a measurement
MA-006- MINITRANS User Guide - Rev 2.1
MAIN
Analn0 0000.0uuu
Analn1 0000.0uuu
Analn2 0000.0uuu
or
13-Oct-15 Page 14 of 25