Download Print this page
Sealey Quality MACHINERY GDM120B/VS Instructions

Sealey Quality MACHINERY GDM120B/VS Instructions

Pillar drill

Advertisement

Quick Links

IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS AND
CAUTIONS. USE THIS PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY
CAUSE DAMAGE OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY INSTRUCTIONS
1.1.
ELECTRICAL SAFETY. p WARNING! It is the user’s responsibility to read, understand and comply with the following:
Electricity At Work Act 1989
Health & Safety at Work Act 1974
Important:
a) Connect the GREEN/YELLOW earth wire to the earth terminal ‘E’.
b) Connect the BROWN live wire to the live terminal ‘L’.
c) Connect the BLUE neutral wire to the neutral terminal ‘N’.
After wiring, check there are no bare wires, that all wires have been correctly connected, that the cable outer insulation
extends past the cable restraint and that the cable restraint is tight.
To re-wire, connect the brown & blue wires as indicated above. DO NOT connect the brown or blue wires to the earth terminal.
Cable extension reels
1.2
GENERAL SAFETY
WARNING! Disconnect drill from mains power before changing accessories, servicing or performing any maintenance.
p
3
3
WARNING! Keep all guards and holding screws in place, tight and in good order. Check regularly for damaged parts. A guard or any
3
other part that is damaged should be replaced, before the drill is used, to ensure it will operate properly and perform its intended
p
function. The safety guard is a mandatory fitting where drill is used in premises covered by the Health & Safety at Work Act.
3
3
3
3
3
3
WARNING! Wear approved eye or face protection when operating this drill. Use a face or dust mask if dust is generated.
3
p
3
3
3
3
3
3
7
7
7
You must
If in any doubt about electrical safety, contact a qualified electrician.
subject to 1.1.10. below).
Ensure the unit is correctly earthed via a three-pin plug.
Use recommended parts only. Non-authorised parts may be dangerous and will invalidate the warranty.
PILLAR DRILL
GDM120B/VS
Blue
Neutra
l
REPLACEMENT FUSES MUST
BE OF THE SAME TYPE AND
RATING AS THE ORIGINAL
Yellow & Green
Earth wire
Brown
Live
wire
Cable
restrai

Advertisement

loading

Summary of Contents for Sealey Quality MACHINERY GDM120B/VS

  • Page 1 PILLAR DRILL GDM120B/VS IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS AND CAUTIONS. USE THIS PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE. 1.
  • Page 2 2. DESCRIPTION 3. TECHNICAL SPECIFICATIONS 4. CONTENT & ASSEMBLY 4.1. Package content fig. 1 Note: Figures are illustrative and may differ in detail from your drill. 4.2. Assembly 4.3. Mounting the drill. For stability and safety it is important fig. 3 fig.
  • Page 3 Pillar Drill Model: GDM120B/VS For Jack Sealey Ltd. Sole importer into the UK of Sealey Quality Machinery. NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.